Pioneer X-CM56 Kullanım Talimatları Kılavuzu - Sayfa 36
Araç Alıcısı Pioneer X-CM56 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Pioneer X-CM56 38 sayfaları. Cd receiver system
Ayrıca Pioneer X-CM56 için: Kullanım Talimatları Kılavuzu (40 sayfalar)
Sayfayı Yazdır
10
Additional information
Cleaning the product
• Unplug the power cord from the power outlet when
cleaning this unit.
• Clean this unit using a soft cloth. For tough dirt, apply
some neutral detergent diluted in 5 to 6 parts water to a
soft cloth, wring out thoroughly, wipe off the dirt, then
wipe again with a soft, dry cloth.
• Alcohol, thinner, benzene, insecticides, etc., could
cause the print or paint to peel off. Also, leaving rubber
or vinyl products in contact with this unit for long periods
of time could mar the cabinet.
• When using chemical-impregnated wipes, etc., read the
cautions included with the wipes carefully.
Cleaning the lens
This unit's lens should not become dirty in normal use, but if
for some reason it should malfunction due to dust or dirt,
consult your nearest Pioneer authorized service center.
Although lens cleaners for players are commercially
available, we advise against using them since some may
damage the lens.
Handling discs
Storing
• Always place discs in their cases and store them
vertically, avoiding hot, humid places, places exposed to
direct sunlight and extremely cold places.
• Be sure to read the cautions included with the disc.
Cleaning discs
• Discs may not play if there are fingerprints or dust on
them. In this case, use a cleaning cloth, etc., to gently
wipe the disc from the inside towards the outside. Do not
use dirty cleaning cloths.
• Do not use benzene, thinner or other volatile chemicals.
Also do not use record spray or antistatic agents.
• For tough dirt, apply some water to a soft cloth, wring out
thoroughly, wipe off the dirt, then wipe off the moisture
with a dry cloth.
• Do not use damaged (cracked or warped) discs.
• Do not let the signal surface of discs get scratched or
dirty.
36
En
• Do not attach pieces of paper or stickers to discs. Doing
so could warp discs, making it impossible to play them.
Also note that rental discs often have labels attached to
them, and the label's glue may have oozed out. Check
that there is no glue around the edges of such labels
before using rented discs.
About specially shaped discs
Specially shaped discs (heart-shaped, hexagonal, etc.)
cannot be played on this unit. Do not attempt to play such
discs, as they could damage this unit.
Auto power off setting
1
Press MENU on the remote control.
"Auto Power Down" will be displayed on the main display.
2
Press ENTER on the remote control.
3
Press /
to switch auto power off setting
ON/OFF.
• Initial setting is set to ON.
Note
• When the auto power off is set to ON, "APD ON" will be
displayed on the main display.
• When the auto power off is set to OFF, "APD OFF" will
be displayed on the main display.
Restoring all the settings to the
defaults
Use the steps below to restore the all settings to their defaults.
1
Press Í to turn the power on.
2
Press MENU and then press / until
"Factory Reset" appears on the display.
3
Press ENTER.
"OK?" will appear.
4
Press ENTER.
• "Resetting" is displayed while the settings are being
restored. Power is turned off.