Pioneer XC-L77 Kullanım Talimatı - Sayfa 34

Araç Alıcısı Pioneer XC-L77 için çevrimiçi göz atın veya pdf Kullanım Talimatı indirin. Pioneer XC-L77 48 sayfaları. Stereo cd receiver; speaker system; stereo cassette deck

Sayfayı Yazdır

7 Using the Tape Deck

Automatically Recording a CD

Tip

It's possible to syn-

chro-record a CD onto

both tape and MD si-

multaneously. Set up

both the tape deck and

the MD recorder ready

for recording (steps 1–

4), then press both

buttons in step 8.

REC

See

the

MJ–L77

manual for more on

MD recording.

The recording direction is set

to 'forward'

The reverse mode is set to

'reverse'

Dolby NR switched on

Unlike some tape decks, there's no need to set recording levels—the deck sets the

right level automatically. Also, when recording, the volume, tone and balance controls

have no effect on the recording. This means that you can record something with the

volume turned right down, if you want.

Before recording, check that the cassette erase tabs have not been broken, and that the

tape is either a type I (normal position) or type II (high position/C r O

record on type IV (metal) tapes using this deck.

If you're recording from the start of a tape, it's a good idea to wind the tape on a little

so that you don't accidently start recording over the leader tape. You can either do this

by hand, or load the tape into the deck and play the tape for 5–6 seconds.

This feature makes recording a CD as simple as possible by automatically starting and

stopping the CD and tape together. There are two modes: 1 track synchro records just a

single track, then stops; all tracks synchro records the whole disc.

TAPE

AUX/CD-R

SOUND

STANDBY/ ON

Load a cassette into the tape deck.

In order to follow these instructions more easily, place the cassette in the tray

with side A face up.

Check the recording direction.

If the tape direction indicator shows 3 , then recording will start from side A.

If it shows 2 , then recording will start from side B.

If you need to change the direction, press

Set the auto-reverse mode.

If you set this to O, then recording will stop after reaching the end of the

current side. If it's set to p or π, then recording will continue onto the

other side of the tape. However, if you start recording in the reverse direction,

(2) only that side of the tape will be recorded, whatever the reverse mode.

For detailed instructions on setting the reverse mode, see page 33.

Turn Dolby NR on or off as required.

Using Dolby NR improves the sound quality of tape recordings that are going

to be played on Dolby NR equipped players. If the tape is not going to be

played on a Dolby NR equipped player (or if you're not sure), you should

leave Dolby NR off.

See page 22 for detailed instructions on switching Dolby NR on/off.

TAPE REC

DISPLAY

SET

TAPE

TIMER/

! —

REC

CHARACTER

CANCEL

twice, then &.

TAPE

) — you can't

›

VOL

+ ⁄