Pioneer XC-P410T Kullanım Talimatları Kılavuzu - Sayfa 14

Araç Alıcısı Pioneer XC-P410T için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Pioneer XC-P410T 40 sayfaları.

Sayfayı Yazdır

1. Table of Contents

TUNING INTO STATIONS

AM-NR/FM-MONO button

DISPLAY button

FREQ/ST.

BOWN-TUNER—UP

Broedcast reception is not possible unless an antenna is

connected, so be sure to connect one.

1 Select AM (MW or LW) or FM with BAND.

2 Press FREG./ST. to select frequency mode.

"TUNER" appears in the display.

3 Press TUNER UP (+) for higher

frequencies or DOWN

(-) for lower

frequencies.

The TUNED indicator lights up when a station of sufficient

signal strength is tuned in.

e One step tuning

Press TUNER UP (+) or DOWN (-) and release quickly.

The frequency will change by one step each time the

button is pressed. Press as many times as necessary to

tune in the desired station.

@ Auto tuning

Press TUNER UP (+) or DOWN (-) until the frequency

starts to change (1-2 sec.}, then release it. The tuner will

automatically search for a broadcasting station and stop

when one is found, and the TUNED indicator lights up.

To search for another station, press again.

NOTE for European and U.K. models:

Auto tuning is not possible on the LW band.

@ High speed manual tuning

Keep TUNER UP (+) or DOWN (-) pressed. The frequency

changes continuously, and stops when the switch is

released.

AM-NR/FM-MONO button

During AM reception:

Cuts out AM broadcast noise to

give you a much clearer sound.

During FM reception: Switches

between

stereo and

monaural modes when listening to a stereo broadcast. If

there is a lot of noise in the stereo position, switch to

MONO and the noise will be suppressed.

Last station memory

The last received AM and FM stations remain stored regardless

of function and/or POWER switching.

To change the display mode:

Each time DISPLAY is pressed, the display switches between

tuner mode and the current time.

DISPLAY

FREQ.