Pioneer AVH-1440NEX Kurulum Kılavuzu - Sayfa 7

Alıcı Pioneer AVH-1440NEX için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Pioneer AVH-1440NEX 25 sayfaları. Dvd rds av receiver

Sayfayı Yazdır

sure you leave ample space behind the

rear panel and wrap any loose cables so

they are not blocking the vents.

5 cm

Leave ample

space

5 cm

Installation using the

screw holes on the side

of this product

Fastening this product to the factory

radio-mounting bracket.

Position this product so that its screw

holes are aligned with the screw holes

of the bracket, and tighten the screws at

three locations on each side.

Use either the truss head screws (5 mm

× 9 mm) or flush surface screws (5 mm ×

9 mm), depending on the shape of the

bracket's screw holes.

Factory radio-mounting bracket

If the pawl interferes with

installation, you may bend it down

out of the way.

Dashboard or console

Truss head screw or flush surface

screw

Be sure to use the screws supplied

with this product.

Installing the

microphone

• Install the microphone in a place where

its direction and distance from the driver

make it easiest to pick up the driver's

voice.

• Be sure to turn off (ACC OFF) the product

before connecting the microphone.

• Depending on the vehicle model, the

microphone cable length may be too

short when you mount the microphone

on the sun visor. In such cases, install the

microphone on the steering column.

Mounting on the sun

visor

Fit the microphone lead into the

groove.

Microphone lead

Groove

Attach the microphone clip to the sun

visor.

Microphone clip

Clamps

Use separately sold clamps to secure

the lead where necessary inside the

vehicle.

Install the microphone on the sun visor

when it is in the up position. It cannot

recognise the driver's voice if the sun

visor is in the down position.

Installation on the

steering column

Detach the microphone base from the

microphone clip by sliding the

microphone base while pressing the

tab.

Tab

Microphone base

Mount the microphone on the

steering column.

Double-sided tape

Clamps

Use separately sold clamps to secure

the lead where necessary inside the

vehicle.

NOTE

Keeping it away from the steering wheel.

Adjusting the

microphone angle