Pioneer DVH-875AVBT Kullanım Kılavuzu - Sayfa 22

Alıcı Pioneer DVH-875AVBT için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Pioneer DVH-875AVBT 36 sayfaları.

Sayfayı Yazdır

Section

Installation

Connecting the unit

WARNING

• To avoid the risk of accident and the

potential violation of applicable laws, no

viewing of front seat video should ever

occur while the vehicle is being driven.

• In some countries or states the viewing

of images on a display inside a vehicle

even by persons other than the driver

may be illegal. Where such regulations

apply, they must be obeyed.

WARNING

L I G H T G R E E N L E A D A T P O W E R

CONNECTOR IS DESIGNED TO DETECT

P A R K E D S T A T U S A N D M U S T B E

CONNECTED TO THE POWER SUPPLY

SIDE OF THE PARKING BRAKE SWITCH.

IMPROPER CONNECTION OR USE OF

THIS LEAD MAY VIOLATE APPLICABLE

LAW AND MAY RESULT IN SERIOUS

INJURY OR DAMAGE.

CAUTION

• PIONEER does not recommend that

you install or service your display unit

yourself. Installing or servicing the

product may expose you to risk of electric

shock or other hazards.

Refer all installation and servicing of your

display unit to authorized Pioneer service

personnel.

• Secure all wiring with cable clamps or

electrical tape. Do not allow any bare

wiring to remain exposed.

• Do not drill a hole into the engine

compartment to connect the yellow

cable of the display unit to the vehicle

battery. Engine vibration may eventually

ca u se th e insulation to fai l at the

p o i n t w h e r e t h e w i r e p a s s e s f r o m

the passenger compartment into the

engine compartment. Take extra care in

securing the wire at this point.

• It is extremely dangerous to allow the

microphone lead to become wound

around the steering column or gearstick.

Be sure to install the unit in such a way

that it will not obstruct driving.

• Make sure that cables will not interfere

with moving parts of the vehicle, such

as the gearshift, parking brake or seat

sliding mechanism.

• Do not shorten any cables. If you do,

the protection circuit may fail to work

properly.

WARNING

• Use speakers over 50 W (output value)

and between 4 Ω to 8 Ω (impedance

value). Do not use 1 Ω to 3 Ω speakers

for this unit.

• T h e b l a c k c a b l e i s g r o u n d . W h e n

installing this unit or power amp (sold

separately), make sure to connect the

ground wire first. Ensure that the ground

wire is properly connected to metal parts

of the car's body. The ground wire of the

power amp and the one of this unit or

any other device must be connected to

the car separately with different screws. If

the screw for the ground wire loosens or

falls out, it could result in fire, generation

of smoke or malfunction.

Ground wire

Other devices

Metal parts of car's body

(Another electronic

device in the car)

Important

• This unit cannot be installed in a vehicle

without ACC (accessory) position on the

ignition switch.

ACC position

No ACC position

• Use this unit with a 12-volt battery and

negative grounding only. Failure to do so

may result in a fire or malfunction.

POWER AMP