Pioneer MVH-089UB Kullanıcı El Kitabı - Sayfa 8
Alıcı Pioneer MVH-089UB için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Pioneer MVH-089UB 16 sayfaları. Digital media receiver
Sayfayı Yazdır
Menu Item
SEEK
[MAN], [PCH]
S.RTRV
USB
[1] (effective for low
compression rates),
[2] (effective for high
compression rates),
[OFF]
AUDIO settings
Menu Item
FADER*1
BALANCE
EQ SETTING
[SUPER BASS], [POWERFUL],
[TODOROKI], [VOCAL],
[CUSTOM1], [CUSTOM2],
[FLAT]
Select an equalizer band and
level for further customizing.
Equalizer band: [80HZ],
[250HZ], [800HZ], [2.5KHZ],
[8KHZ]
Equalizer level: [+6] to [–6]
8
En
Description
Assign
or
buttons to seek the
stations one by one (manual tuning) or
select a station from the preset channels.
Enhance compressed audio and restore
rich sound.
Description
Adjust the front and rear speaker balance.
Adjust the left and right speaker balance.
Select or customize the equalizer curve.
[CUSTOM1] can be set separately for each
source. However, each of the below
combinations are set to the same setting
automatically.
[CUSTOM2] is a shared setting used for all
sources.
You can also switch the equalizer by
pressing
repeatedly.
Menu Item
LOUDNESS
[OFF], [LOW], [MID], [HI]
SUB.W*2
[NOR], [REV], [OFF]
SUB.W CTRL*2*3
Cut-off frequency: [50HZ],
[63HZ], [80HZ], [100HZ],
[125HZ], [160HZ], [200HZ]
Output level: [–24] to [+6]
Slope level: [–12], [–24]
BASS BOOST
[0] to [+6]
HPF SETTING
Cut-off frequency: [OFF],
[50HZ], [63HZ], [80HZ],
[100HZ], [125HZ], [160HZ],
[200HZ]
Slope level: [–12], [–24]
SLA
[+4] to [–4]
*1 Not available when [SUB.W/SUB.W] is selected in [SP-P/O MODE] in the INITIAL settings
(page 5).
*2 Not available when [REAR/REAR] is selected in [SP-P/O MODE] in the INITIAL settings
(page 5).
*3 Not available when [OFF] is selected in [SUB.W].
SYSTEM settings
You can also access to these menus when the unit is turned off.
Description
Compensate for clear sound at low volume.
Select the subwoofer phase.
Only frequencies lower than those in the
selected range are output from the
subwoofer.
Select the bass boost level.
Only frequencies higher than the high-pass
filter (HPF) cutoff are output from the
speakers.
Adjust the volume level for each source
except FM.