Pioneer VSX-454 Kullanım Talimatları Kılavuzu - Sayfa 20
Alıcı Pioneer VSX-454 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Pioneer VSX-454 27 sayfaları. Audio/video stereo receiver
Sayfayı Yazdır
REMOTE CONTROL OPERATION
[RECEIVER TUNER AND AMPLIFIER SECTION OPERATION
6 &
oO
®
®@
@
@
ro
@
0
5
2
rN
i]
@—tiLe
a3
@
@ PIONEER
ARO BSR
NS a
ere oe
[TUNER SECTION OPERATION]
lO
switch
to AUDIO.
@ FREQUENCY "+ " (Up) "— "(Down} buttons
Shifts the frequency up
(+) and down ( —).
@ STATION" +" (Up) "— "(Down) buttons
Used for recalling memorized stations.
Auto tuning:
Press FREQUENCY
+ (up) or — (down) button until the
frequency starts to change, then release it. The tuner will
automatically search for a broadcasting station and stops when
one is found, and the TUNED indicator lights up. To search for
another station, press again.
Manual tuning:
Press FREQUENCY + (up) or — (down) button and release
quickly. The tuning frequency will change by one step each
time the button is pressed. Press as many times as necessary
to tune in the desired station. The TUNED indicator lights up
when the station is tuned in best.
+ If you keep the FREQUENCY ( + /— } button depressed after
the frequency has began to change, the reception frequency
changes continuously, and stops when the button is released.
NOTE:
When AUTO TUNING is in use, reception may not be possible over
long distances or when signals are weak, At these times MANUAL
TUNING is recommended.
20
<ARB7025>
[AMPLIFIER SECTION OPERATION]
@ FUNCTION button
Press to select the receiver input.
p—* TAPE 1VCR
——*
PHONO ——+
TUNER)
cD «
LD «
& TAPE 2 MONITOR button
Switches TAPE 2 MONITOR ON/OFF.
@ 3CH LOGIC button
Switches DOLBY 3CH LOGIC ON/OFF.
& MUTING button
Press to temporarily reduce sound. When
set to the on
position, MUTING is displayed. Press again to return to the
original volume level.
(6) SURR. (Surround) MODE button
The surround mode is switched in the following manner each
time the button is pressed:
DOLBY PRO-LOGIC SURROUND
—* STUDIO
OFF +———
SIMULATED SURROUND
@® CENTER MODE/TEST TONE button
AUDIONID
witch : AUDI
iti
Functions as a CENTER MODE button, enabling selection
of the DOLBY PRO-LOGIC SURROUND and DOLBY 3CH
LOGIC center mode.
AUDION
ID:
i
Vi
iti
Functions as a TEST TONE button for switching the test
tone ON/OFF.
Used to adjust the test tone volume level from each speaker.
When the test tone is switched ON, the test tone is output
through each speaker in turn for about two seconds. (The
channel outputting the test tone is indicated in the display.)
Adjust volume level so that it is the same from each speaker,
® RECEIVER POWER button
Switches the receiver power ON/STANDBY.
4 RETURN button
Press to return the receiver to it's initial state. (Refer to page 11.)