Pioneer AVH-P3200BT Kurulum Kılavuzu - Sayfa 11

Stereo Alıcı Pioneer AVH-P3200BT için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Pioneer AVH-P3200BT 40 sayfaları. Dvd, rds, av receiver
Ayrıca Pioneer AVH-P3200BT için: Kurulum Kılavuzu (8 sayfalar)

Sayfayı Yazdır

Installation

Note

• Check all connections and systems before final

installation.

• Do not use unauthorized parts as this may cause

malfunctions.

• Consult your dealer if installation requires drilling

of holes or other modifications to the vehicle.

• Do not install this unit where:

— it may interfere with operation of the vehicle.

— it may cause injury to a passenger as a result

of a sudden stop.

• Do not install the display where it may (i) obstruct

the driver's vision, (ii) impair the performance of

any of the vehicle's operating systems or safety

features, including air bags, hazard lamp buttons

or (iii) impair the driver's ability to safely operate

the vehicle.

• The semiconductor laser will be damaged if it

overheats. Install this unit away from hot places

such as near the heater outlet.

• Optimum performance is obtained when the unit

is installed at an angle of less than 30°.

• When installing, to ensure proper heat dispersal

when using this unit, make sure you leave ample

space behind the rear panel and wrap any loose

cables so they are not blocking the vents.

Leave ample space

• To some types of vehicles, this unit cannot be

properly installed. In such case, use the optional

installation kit (ADT-VA133).

Installation using the screw

holes on the side of the unit

Factory radio mounting bracket

Dashboard

Use either truss

(5 mm × 8 mm) or

flush surface (5 mm

× 9 mm) screws,

depending on the

bracket screw holes.

In some types of vehicles, discrepancy may

occur between the unit and the dashboard. If this

happens, use the supplied frame to fill the gap.

Fastening the unit to the factory

radio-mounting bracket.

Position the unit so that its screw holes are

aligned with the screw holes of the bracket,

and tighten the screws at 3 or 4 locations on

each side.

If the pawl gets in the way,

bend it down.

Note

Dashboard or console