Ariston A1636 Kullanım ve Bakım & Kurulum Talimatları Kılavuzu - Sayfa 12

Yıkayıcı Ariston A1636 için çevrimiçi göz atın veya pdf Kullanım ve Bakım & Kurulum Talimatları Kılavuzu indirin. Ariston A1636 16 sayfaları. Ariston washing machine use and care & installation instruction a1636s, a1636, a1436, a1235

Sayfayı Yazdır

Care and maintenance

Cutting off the water or electricity

supply

Turn off the water tap after every wash. This will

limit the wear of your appliances water system

and also prevent leaks.

Unplug your appliance when cleaning it and

during all maintenance operations.

Cleaning your appliance

The exterior and rubber parts of your appliance can

be cleaned with a soft cloth soaked in lukewarm

soapy water. Do not use solvents or abrasives.

Cleaning the detergent dispenser

Caring for your appliance door and

drum

Always leave the appliance door ajar to prevent

unpleasant odours from forming.

Checking the water inlet hose

Check the water inlet hose at least once a year. If

you see any cracks, replace it immediately: during

the wash cycles, high water pressure could cause a

cracked hose to split open.

! Never use hoses that have already been used.

Remove the dispenser by

raising it and pulling it out

(see figure).

Wash it under running

water; this operation

should be repeated

frequently.

Fuses

Your appliance comes fitted with a plug and a 13

amp (13A) fuse. If you need to replace the fuse,

use only those rated at 13 amp (13A) and ASTA

approved to BS1362. To change the fuse, insert the

fuse and push the fuse holder down into the locked

position. Correct replacement is identified by colour

coding or the marking on base of the plug.

! DO NOT use the plug unless the fuse holder is in

the locked position and the top cover firmly

replaced.

Changing the Plug

If you need to change your plug, if it does not fit

your socket: isolate the machine from the mains

supply. Cut off the supplied plug and safely dispose

of the discarded plug. DO NOT plug into any other

socket.

NOTE: If you change the plug, the colour of wires in

the mains lead may not match the colour of the

markings which show the different terminals in the

plug. You must wire it as shown below:

Green and Yellow (Earth)

wire to terminal marked 'E',

symbol

, or coloured

green and yellow.

Blue (Neutral) wire to

terminal marked 'N' or

coloured black.

13A ASTA approved fuse to

BS1362.

Brown (Live) wire to terminal

marked 'L' or coloured red.