Pioneer VSX-D309 Kullanım Talimatları Kılavuzu - Sayfa 29
Stereo Alıcı Pioneer VSX-D309 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Pioneer VSX-D309 48 sayfaları. Audio/video multi-channel receiver
Sayfayı Yazdır
Playing Sources with Dolby Digital or DTS Sound
Î
MULTI CONTROL
DVD/LD TV/SAT VCR/DVR
CD
CD-R/
3
RECEIVER TUNER
TV CONT
TAPE/MD
2
DSP MODE MIDNIGHT 5.1CH
2
1
2
3
4
CHANNEL
TEST
SIGNAL
SELECT
TONE
ATT
SELECT
5
6
7
8
CHANNEL
EFFECT
LEVEL
‡
9
0
ENTER
10
DISC
CH
FUNC
TV CONTROL
VOL
VOL
FQ
ST
ST
ENTER
TOP
MENU
MENU
FQ
SOURCE CLASS
MPX
BAND
7
8
3
D.ACCESS
CHANNEL
1
¡
4
¢
LOUDNESS FUNCTION MUTING
FL
REMOTE
MASTER
1
RECEIVER
DIMMER
SETUP
VOLUME
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
1
3
memo
When playing LD recorded in Dolby Digital
When connecting a DVD/LD player or LD player using the 2 RF (AC-3) output, a commercially available
RF demodulator (RFD-1) is required. The RF demodulator changes the RF signal to a digital signal
which is then processed by the receiver at the digital input jacks. For more details, refer to the instruction
manual supplied with the RFD-1.
1 Follow steps 1 to 3 of the playback
procedure. (Refer to "Playing a source" on
the previous page.)
1 Turn on the power of the playback component.
2 Turn on the power of the receiver.
3 Press FUNCTION to select the source component you want to
play.
2
2 Press SIGNAL SELECT to select DIGITAL.
(Refer to "Switching ANALOG/DIGITAL signal input" on the
previous page.)
3 Press
4 Start playback of the component you
5
selected in step 1.
5 Press MASTER VOLUME (+/–) to adjust the
volume level.
2
memo
5
2
to switch the Dolby/DTS mode on.
• When an LD or CD player compatible with DTS is
played back with SIGNAL SELECT set in "ANALOG",
digital noise is output caused by playing back the DTS
directly (no decoding). To prevent noise, you need to
make digital connections (refer to pages 11) and set
SIGNAL SELECT to "DIGITAL".
Sound Modes
29