Pioneer VSX-D498 Kullanım Talimatları Kılavuzu - Sayfa 15

Stereo Alıcı Pioneer VSX-D498 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Pioneer VSX-D498 48 sayfaları. Audio/video multi-channel receiver

Sayfayı Yazdır

Preparations

Setting Up for Surround Sound

Be sure to switch the power of this unit on (The STANDBY indicator goes out) before operating.
To ensure the best possible surround sound, be sure to complete the following set up operations. This is particularly
important when using the
the placement of your current speaker system or add new speakers, etc.). Refer to the following pages for detailed
descriptions of the settings available for each mode.
SOURCE
SELECT
CHANNEL
CD
STANDBY/ON
STATION
TV FUNC.
TV VOL.
TAPE
BAND
FREQ.
DIRECT
TUNER
MPX
CLASS
.ACCESS
DVD
1
2
3
LD
4
5
6
TV
CONTROL
TEST TONE
7
8
9
ATT.
2
SURROUND
CD DISC
0
FUNCTION
DSP MODE
MUTING
CHANNEL
SELECT
LEVEL
RECEIVER
MASTER
VOLUME
STANDBY/ON
EFFECT
1
AV MULTI-CHANNEL RECEIVER
Î
REMOTE CONTROL UNIT
memo
• The setting mode is automatically exited
if no operation is performed for 20
seconds.
(Dolby) Surround mode. You only need to make these settings once (unless you change
1
Press RECEIVER
The STANDBY indicator goes out.
2
Press SURROUND.
This switches the remote to the surround setup mode.
3
3
Press @ or # to select the mode you desire.
For best results, start with "SPEAKER setting mode" and make your
4
initial adjustments in the order described below.
The current settings are displayed automatically.
SPEAKER (Front, Center, Surround) setting mode (page 16)
Use to specify the type of speakers you have connected.
SUB WOOFER ON/OFF setting mode (page 17)
Use to specify the sub woofer as on or off.
Crossover frequency setting mode (page 17)
Use to determine which frequencies will be sent to the sub woofer or
"Large" speakers.
LFE attenuator setting mode (page 17)
Use to specify the peak level for the LFE channel and the crossover
network for rerouted bass frequencies.
Low cut filter ON/OFF setting mode (page 18)
Use to cut the distorted sound from the sub woofer.
FRONT speaker distance setting mode (page 18)
Use to specify the distance from your listening position to your front speaker.
CENTER speaker distance setting mode (page 18)
Use to specify the distance from your listening position to your center speaker.
SURROUND speaker distance time setting mode (page 18)
Use to specify the distance from your listening position to your surround speakers.
Dynamic range control setting mode (page 19)
Use to compress the dynamic range of the sound track.
Coaxial digital input setting (page 19)
Use to specify the input to be assigned to the coaxial digital input.
Optical digital input 1 setting (page 19)
Use to specify the input to be assigned to the optical digital input 1.
Optical digital input 2 setting (page 19)
Use to specify the input to be assigned to the optical digital input 2.
4
Press % or fi to select the setting you desire.
The setting is entered automatically.
5
Repeat steps 3 and 4 to set other surround modes.
STANDBY/ON to turn the power on.
15
<ARB7192>