Pioneer XC-L77 Kullanım Talimatı - Sayfa 44
Stereo Alıcı Pioneer XC-L77 için çevrimiçi göz atın veya pdf Kullanım Talimatı indirin. Pioneer XC-L77 48 sayfaları. Stereo cd receiver; speaker system; stereo cassette deck
![Pioneer XC-L77 Kullanım Talimatı](/uploads/products/server2/6624025/6624025.png)
9 Additional Information
Troubleshooting
Incorrect operation can be mistaken for trouble or malfunction. If you think that there is something wrong with this component,
check the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical
appliances being used. If the trouble cannot be rectified even after exercising the checks below, ask your nearest Pioneer authorized
service station to carry out repair work.
Symptom
Power turns off
abruptly during
operation.
No sound
Can't switch between
functions.
Play doesn't start when
the play/pause button
is pressed.
Can't listen to
broadcasts, or sound is
distorted.
Broadcast is in stereo,
but sound from
speakers is monaural.
Can't record
Sound is muddy or
distorted. When record-
ing over a previous
recording, the old
recording can still be
heard underneath.
44
Likely Cause
• Cooling fan vent is blocked.
• The CD receiver has been set on top of soft cloth
or deep-pile rug, thus blocking the cooling vents.
• Power plug is disconnected.
• Not all connection cables are connected properly.
• Unit is in demo mode.
• Cassette deck or MD recorder is currently
recording.
• Disc has been inserted upside down.
• Disc is dirty.
• Disc has scratches.
• Antenna isn't connected.
• Antenna direction or position is poor.
• An electrical appliance (fluorescent lamp, hair
dryer, etc.), including the fluorescent display of
this system, is being used in the near vicinity.
• The frequency interval is incorrectly set.
• Monaural indicator is lit in the display.
• Erasure-prevention tabs are broken out from the
tape cassette.
• Heads are dirty.
• A type IV (Metal) tape is being used.
Remedy
• Install so that the fan is not blocked.
• Do not install the CD receiver on top of any
surface that may block the vents.
• Connect the power plug correctly.
• Refer to the section on connections and make
sure all connections are correct and secure.
• To cancel the demo mode, press the power
switch on either of the CD receiver, display
unit, or remote control unit while the demo
mode is operating.
• You cannot change the function during
recording.
• Load discs with label side (printed surface)
upwards.
• Clean the disc.
• Use another disc.
• Connect antennas properly.
• Orient antenna to the proper direction and
position.
• Discontinue use of the appliance producing the
noise, or move it farther away from the
antenna.
• Adjust the tuning frequency interval correctly
(p.45).
• Use the MENU button to select "FM AUTO"
(p.19).
• Either replace the tape, or place cellophane
tape over the erasure-prevention tabs (p.6).
• Clean the heads (p.46).
• Use either a type I (Normal), or Type II (C
tape.
0
)
r
2