Pioneer C-90S Kullanım Talimatları Kılavuzu - Sayfa 31
Amplifikatör Pioneer C-90S için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Pioneer C-90S 32 sayfaları. Stereo control amplifier
Sayfayı Yazdır
ed.
Symptom
Probable Cause
Remedy
No power
Power plug is disconnected from outlet
If the power piug is connected to the switched
auxiliary outlet of another component, the
power is turned OFF to the other component.
¢ Connect plug securely into power outlet.
Turn on the power to the other component.
No sound
A short pin plugs is connected to the REC,
AUDIO OUT terminal.
Connection cords are disconnected from ter-
minals, or connected incorrectly.
©
ee
* Remove short pin plug.
* Connect cords securely
White plug
: a
Red plug
saa
Terminals and/or connecting cord plugs are
dirty
The audio adaptor switch is set incorrectly
The input selector switch is not set to the
playback component.
Other components are being operated incor-
rectly.
* Clean plugs and terminais
© Set to ON when using an adaptor component,
and OFF at all other times.
* Consult the operating instructioOns for the ta-
pe deck used.
* Set the switch correctly.
© Consult the operating instructions for the other
components.
No picture
A short pin plug is connected to the VIDEO
OUT terminal.
Connection cords are disconnected from ter-
minals, or connected incorrectly.
9)
Terminals and connection cord pin-plugs are
dirty.
Input selector switch or video signal selector
switch is not set to the playback component.
The video adaptor switch is set incorrectly.
Other components are being operated incor-
rectly.
* Remote short pin plug.
Connect correctly and securely.
co
Clean terminals and pin-plugs.
Set switches correctly.
The indicator for
the playback
component
should light.
Set to ON when using an adaptor component,
and OFF at all other times.
* Consult the operating instructions for the other
components.
No sound from one speaker.
~—-+
Connection cords are disconnected from one
side.
The balance control is set too far to one side.
* Connect cords securely.
* Set the control to the center position.
31
<ARB1140>