Pioneer GM-3400T Kullanıcı El Kitabı - Sayfa 11

Amplifikatör Pioneer GM-3400T için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Pioneer GM-3400T 17 sayfaları. Bridgeable two-channel power amplifier
Ayrıca Pioneer GM-3400T için: Kullanıcı El Kitabı (41 sayfalar), Kullanıcı El Kitabı (48 sayfalar)

Sayfayı Yazdır

( Installation

)

---------------~/

section

(

),.

~.-----------~/~

Before installing the amplifier

AWARNING

•

To ensure proper installation, use the supplied

parts in the manner specified. If any parts

other than those supplied are used, they may

damage internal parts of the amplifier, or be-

come loose causing the amplifier to shut

down.

•

Do not install in:

Places where it could injure the driver or

passengers if the vehicle stops suddenly.

Places where it may interfere with the dri-

ver, such as on the floor in front of the dri-

ver's seat.

•

Install tapping screws in such a way that the

screw tip does not touch any wire. This is im-

portant to prevent wires from being cut by vi-

bration of the car, which can result in fire.

•

Make sure that wires are not caught in the

sliding mechanism of the seats, resulting in a

short-ci rcu it.

•

When drilling to install the amplifier, always

confirm no parts are behind the panel and

protect all cables and important equipment

(e.g. fuel/brake lines, wiring) from damage.

CAUTION

•

To ensure proper heat dissipation of the ampli-

fier, ensure the following during installation:

Allow adequate space above the amplifier

for proper ventilation.

Do not cover the amplifier with a floor mat

or carpet.

•

Avoid routing wires through hot areas, such

as near the heater outlet. Heat may damage

the insulation, resulting in a short-circuit

through the vehicle body.

• The optimal installation location differs de-

pending on the car model. Secure the ampli-

fier at a sufficiently rigid location.

•

Firstly make temporary connections and

check to ensure the amplifier and system op-

erate properly.

•

After installing the amplifier, confirm that the

_____ .1.: __

: __

1. __ -I L __ l ....

~I.

. .__

::>fJart: lIrt:,JaU\aIIU lUUI::> Lall ueea;:'IIY re-

moved.C!J

Example of installation on

the floor mat or chassis

Place the amplifier in the desired instal-

lation location.

Insert the supplied tapping screws (4 mm x

18 mm) into the screw holes and push on the

screws with a screwdriver so they make an im-

print where the installation holes are to be lo-

cated.

Drill 2.5 mm (1/8 inch) diameter holes

at the imprints either on the carpet or di-

rectly on the chassis.

Install the amplifier with the use of

supplied tapping screws (4 mm x 18 mm).

Tapping-screws (4 mm x 18

mm)

Drill a 2.5 mm (1/8 inch) diameter hole

Floor mat or chassis

[!J

CID