Pioneer GM-A4604 Kullanıcı El Kitabı - Sayfa 11

Amplifikatör Pioneer GM-A4604 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Pioneer GM-A4604 49 sayfaları. Bridgeable four-channel power amplifier
Ayrıca Pioneer GM-A4604 için: Kullanıcı El Kitabı (19 sayfalar), Kullanıcı El Kitabı (14 sayfalar)

Sayfayı Yazdır

Connecting the units

1 Car Stereo

2 Speaker output

3 White/black: CH A, Left *

4 White: CH A, Left +

5 Gray/black: CH A, Right *

6 Gray: CH A, Right +

7 Green/black: CH B, Left *

8 Green: CH B, Left +

9 Violet/black: CH B, Right *

a Violet: CH B, Right +

b Speaker input connector

To speaker input terminal of this unit.

Note

If speaker input wires from a headunit are con-

nected to this amplifier, the amplifier will automa-

tically turn on when the headunit is turned on.

When the headunit is turned off, the amplifier

turns off automatically. This function may not

work with some headunits. In such cases, please

use a system remote control wire (sold sepa-

rately). If multiple amplifiers are to be connected

together synchronously, connect the head unit

and all amplifiers via the system remote control

wire.

Connecting the power

terminal

The use of a special red battery and ground

wire RD-223 (sold separately) is recom-

mended. Connect the battery wire directly to

the car battery positive terminal + and the

ground wire to the car body.

WARNING

If the battery wire is not securely fixed to the term-

inal using the terminal screws, there is a risk of

overheating, malfunction and injury, including

minor burns.

Route battery wire from engine com-

partment to the vehicle interior.

! When drilling a cable pass-hole into the ve-

hicle body and routing a battery wire thor-

ough it, take care not to short-circuit the

wire damaging it by the cut edges or burrs

of the hole.

After completing all other amplifier connec-

tions, finally connect the battery wire terminal

of the amplifier to the positive + battery term-

inal.

1 Positive + terminal

2 Engine compartment

3 Vehicle interior

4 Fuse (30 A) × 2

5 Insert the O-ring rubber grommet into the

vehicle body.

6 Drill a 14 mm (1/2 in.) hole into the vehicle

body.

Twist the battery wire, ground wire

and system remote control wire.

Attach lugs to wire ends.

Use pliers, etc., to crimp lugs to wires.

1 Lug (sold separately)

2 Battery wire

3 Ground wire

Section

Twist