Pioneer GM-A6604 Kullanıcı El Kitabı - Sayfa 6

Amplifikatör Pioneer GM-A6604 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Pioneer GM-A6604 14 sayfaları. Bridgeable four-channel power amplifier
Ayrıca Pioneer GM-A6604 için: Kullanıcı El Kitabı (49 sayfalar), Kullanıcı El Kitabı (19 sayfalar)

Sayfayı Yazdır

Section

Connecting the units

Connection diagram

1 Special red battery wire

RD-223 (sold separately)

After completing all other amplifier connec-

tions, finally connect the battery wire terminal

of the amplifier to the positive + battery term-

inal.

2 Ground wire (Black)

RD-223 (sold separately)

Connect to metal body or chassis.

3 Car stereo with RCA output jacks (sold sepa-

rately)

4 External output

If only one input plug is used, do not connect

anything to RCA input jack B.

5 Connecting wire with RCA pin plugs (sold se-

parately)

6 RCA input jack A

7 RCA input jack B

8 Speaker input terminal (use a connector in-

cluded)

Please see the following section for speaker

connection instructions. Refer to Connections

when using the speaker input wire.

9 Speaker output terminals

Please see the following section for speaker

connection instructions. Refer to Connections

when using the speaker input wire.

a System remote control wire (sold separately)

Connect male terminal of this wire to the sys-

tem remote control terminal of the car stereo.

The female terminal can be connected to the

auto-antenna relay control terminal. If the car

stereo lacks a system remote control terminal,

connect the male terminal to the power term-

inal via the ignition switch.

b Fuse 25 A × 2 (GM-A6604) / 30 A × 1 (GM-

A4604)

c Fuse (30 A) × 2

d Grommet

e Rear side

f Front side

Note

INPUT SELECT (input select) switch must be set.

For details, see Setting the unit on page 4.

Before connecting the

amplifier

WARNING

! Secure the wiring with cable clamps or adhe-

sive tape. To protect the wiring, wrap sections

in contact with metal parts in adhesive tape.

! Never cut the insulation of the power supply

to feed power to other equipment. Current ca-

pacity of the wire is limited.

CAUTION

! Never shorten any wires, the protection circuit

may malfunction.

! Never wire the speaker negative cable directly

to ground.

! Never band together multiple speaker's nega-

tive cables.