Pioneer GM-D8601 Kullanıcı El Kitabı - Sayfa 7

Amplifikatör Pioneer GM-D8601 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Pioneer GM-D8601 45 sayfaları. Class d mono amplifier
Ayrıca Pioneer GM-D8601 için: Kullanıcı El Kitabı (15 sayfalar), Kullanıcı El Kitabı (49 sayfalar)

Sayfayı Yazdır

Connecting the units

Connection diagram

1 Battery wire (sold separately)

! The maximum length of the wire be-

tween the fuse and the positive + term-

inal of the battery is 30 cm (12 in.).

! For the wire size, refer to Connecting the

power terminal on page 9. The battery

wire, the ground wire and the optional

direct ground wire must be same size.

After making all other connections at

the amplifier, connect the battery wire

terminal of the amplifier to the positive

+ terminal of the battery.

2 Fuse 100 A (GM-D8601) / 150 A (GM-D9601)

(sold separately)

Each amplifier must be separately fused at

100 A (GM-D8601) / 150 A (GM-D9601).

3 Positive (+) terminal

4 Negative (*) terminal

5 Battery (sold separately)

6 Ground wire, Terminal (sold separately)

The ground wires must be same size as the

battery wire.

Connect to metal body or chassis.

7 Car stereo with RCA output jacks (sold sepa-

rately)

8 External output

9 Connecting wire with RCA pin plugs (sold se-

parately)

a Amplifier with RCA input jacks (sold sepa-

rately)

b Bass boost level remote control

c Bass boost level remote control wire (5 m

(16 ft. 5 in.))

d RCA input jack

e RCA output jack

f System remote control wire (sold separately)

Connect male terminal of this wire to the sys-

tem remote control terminal of the car stereo.

The female terminal can be connected to the

auto-antenna relay control terminal. If the car

stereo lacks a system remote control terminal,

connect the male terminal to the power term-

inal via the ignition switch.

g Speaker output terminals

Please see the following section for speaker

connection instructions. Refer to Connections

when using the speaker input wire on page 9.

h Fuse 40 A × 2 (GM-D8601) / 40 A × 3 (GM-

D9601)

i Front side

j Rear side

Before connecting the

amplifier

WARNING

! Secure the wiring with cable clamps or adhe-

sive tape. To protect the wiring, wrap sections

in contact with metal parts in adhesive tape.

! Never cut the insulation of the power supply

to feed power to other equipment. Current ca-

pacity of the wire is limited.

CAUTION

! Never shorten any wires, the protection circuit

may malfunction.

! Never wire the speaker negative cable directly-

to ground.

Section