Pioneer GM-DX975 Kullanıcı El Kitabı - Sayfa 8

Amplifikatör Pioneer GM-DX975 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Pioneer GM-DX975 17 sayfaları. Class d five-channel amplifier

Sayfayı Yazdır

Connecting the units

)

- - -

Battery wire and ground wire size

less than 2.2 m (7ft

in.)

less than 3.6 m (11 ft

10in.)

less than 6.4 m (20ft

in.)

8AWG

6AWG

4AWG

Route battery wire from engine com-

partment to the vehicle interior.

•

When drilling a cable pass-hole into the ve-

hicle body and routing a battery wire thor-

ough it, take care not to short-circuit the

wire damaging it by the cut edges or burrs

of the hole.

After completing all other amplifier connec-

tions, finally connect the battery wire terminal

of the amplifier to the positive® battery term-

inal.

Positive (±) terminal

Battery wire (sold separately)

The maximum length of the wire between

the fuse and the positive(±) terminal of the

battery is 30 cm (12 in.).

Fuse (100 A) (sold separately)

Each amplifier must be separately fused at

100A.

Use wire cutters or a utility knife to

strip the end of the battery wire, ground

wire and system remote control wire to ex-

pose about 10 mm (3/8 in.) of the end of

each of the wires, and then twist the ex-

posed ends of the wires.

Twist

---•

10mm

(3/8in.)

Connect the wires to the terminal.

Fix the wires securely with the terminal

screws.

Battery wire

Power terminal

Ground wire

@ Ground terminal

System remote control wire

System remote control terminal

(J)

Terminal screws