Pioneer GM5400T - Bridgeable Amplifier Kullanıcı El Kitabı - Sayfa 11

Amplifikatör Pioneer GM5400T - Bridgeable Amplifier için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Pioneer GM5400T - Bridgeable Amplifier 41 sayfaları. Bridgeable two-channel power amplifier
Ayrıca Pioneer GM5400T - Bridgeable Amplifier için: Kullanıcı El Kitabı (48 sayfalar), Kullanıcı El Kitabı (17 sayfalar), Kullanıcı El Kitabı (17 sayfalar), Servis Kılavuzu (29 sayfalar)

Sayfayı Yazdır

Pioneer GM5400T - Bridgeable Amplifier Kullanıcı El Kitabı

Installation

Before installing the amplifier

WARNING

! To ensure proper installation, use the supplied

parts in the manner specified. If any parts

other than those supplied are used, they may

damage internal parts of the amplifier, or be-

come loose causing the amplifier to shut

down.

! Do not install in:

— Places where it could injure the driver or

passengers if the vehicle stops suddenly.

— Places where it may interfere with the dri-

ver, such as on the floor in front of the dri-

ver's seat.

! Install tapping screws in such a way that the

screw tip does not touch any wire. This is im-

portant to prevent wires from being cut by vi-

bration of the car, which can result in fire.

! Make sure that wires are not caught in the

sliding mechanism of the seats, resulting in a

short-circuit.

! When drilling to install the amplifier, always

confirm no parts are behind the panel and

protect all cables and important equipment

(e.g. fuel/brake lines, wiring) from damage.

CAUTION

! To ensure proper heat dissipation of the ampli-

fier, ensure the following during installation:

— Allow adequate space above the amplifier

for proper ventilation.

— Do not cover the amplifier with a floor mat

or carpet.

! Avoid routing wires through hot areas, such

as near the heater outlet. Heat may damage

the insulation, resulting in a short-circuit

through the vehicle body.

! The optimal installation location differs de-

pending on the car model. Secure the ampli-

fier at a sufficiently rigid location.

! Firstly make temporary connections and

check to ensure the amplifier and system op-

erate properly.

! After installing the amplifier, confirm that the

spare tire, jack and tools can be easily re-

moved.

Example of installation on

the floor mat or chassis

Place the amplifier in the desired instal-

lation location.

Insert the supplied tapping screws (4 mm ×

18 mm) into the screw holes and push on the

screws with a screwdriver so they make an im-

print where the installation holes are to be lo-

cated.

Drill 2.5 mm (1/8 inch) diameter holes

at the imprints either on the carpet or di-

rectly on the chassis.

Install the amplifier with the use of

supplied tapping screws (4 mm × 18 mm).

1 Tapping-screws (4 mm × 18 mm)

2 Drill a 2.5 mm (1/8 inch) diameter hole

3 Floor mat or chassis

Section