Pioneer PRS-D1000M Kullanıcı El Kitabı - Sayfa 8
Amplifikatör Pioneer PRS-D1000M için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Pioneer PRS-D1000M 50 sayfaları. Class d mono amplifier
Ayrıca Pioneer PRS-D1000M için: Kullanıcı El Kitabı (9 sayfalar), Kullanıcı El Kitabı (9 sayfalar), Servis Kılavuzu (38 sayfalar)
Sayfayı Yazdır
Connecting the Unit
Connecting the Power Terminal
• Always use the special red battery and ground
wire ([RD-223] and [RD-222]), which are sold
separately. Connect the battery wire directly to
the car battery positive terminal (+) and the
ground wire to the car body. There is the risk of a
fuse burning out if only one of these is connected.
1. Pass the battery wire from the
engine compartment to the interior
of the vehicle.
• After making all other connections to the
amplifier, connect the battery wire terminal
of the amplifier to the positive (+) terminal of
the battery.
[RD-223]
Fuse (30 A)
Fuse (30 A)
Positive terminal
Insert the O-ring rubber
grommet into the vehicle
body.
[RD-222]
Fuse (30 A)
Positive terminal
Insert the O-ring rubber
grommet into the vehicle
body.
7
Engine
compart-
Interior of
ment
the vehicle
Drill a 14 mm
(1/2 inch) hole
into the vehicle
body.
Engine
Interior of
compart-
the vehicle
ment
Drill an 8 mm
(3/8 inch) hole
into the vehicle
body.
2. Twist the battery wire, ground wire
and system remote control wire.
3. Attach lugs to wire ends. Lugs not
supplied.
• Use pliers, etc., to crimp lugs to wires.
Lug
Battery wire
4. Connect the wires to the terminal.
• Fix the wires securely with the terminal
screws.
GND terminal
Power terminal
Battery wire
WARNING
Failure to securely fasten the battery wire to the ter-
minal using the terminal screws could cause the ter-
minal area to overheat and could result in damage
and injury including minor burns.
Twist
Lug
Ground wire
System remote
control terminal
System remote
control wire
Ground wire