Pioneer RS-A99 Kullanıcı El Kitabı - Sayfa 11

Amplifikatör Pioneer RS-A99 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Pioneer RS-A99 16 sayfaları. Optical digital reference system bridgeable four-channel power amplifier

Sayfayı Yazdır

1. Specifications

Connecting the units

2 Connecting wires with RCA plugs (sold sepa-

rately)

3 From RS-P99 (sold separately) etc. (RCA out-

put)

Solderless terminal

connections

! Do not connect cords with exposed core

wires to the amplifier power terminals

(power terminal, ground terminal, system

remote control terminal), since disconnec-

tion or breakage may result in fire or short-

circuit.

! Periodically inspect and tighten the wire as

necessary.

! Do not solder or bind the ends of the

twisted wires.

! Fasten while ensuring the insulating

sheath of the wire is not clamped.

! Use the supplied hexagonal wrench to

tighten and loosen the terminal screw of

the amplifier and use it to securely fasten

the wire. Be careful to avoid excessive tigh-

tening of this screw, which may damage

the wire.

CAUTION

Use the supplied hexagonal wrench to tighten

the screws when fastening wires to the terminal.

The use of a long, commercially available hexago-

nal wrench may exert excessive torque, possibly

resulting in damage to the terminals and

wires.

Connecting the power

terminal

WARNING

! The use of a special red battery and ground

wire RD-228, available separately, is recom-

mended. Connect the battery wire directly to

the car battery positive terminal (+) and the

ground wire to the car body.

! If the battery wire is not securely fixed to the

terminal using the terminal screws, there is a

risk of overheating, malfunction and injury, in-

cluding minor burns.

Route battery wire from engine com-

partment to the vehicle interior.

After completing all other amplifier connec-

tions, finally connect the battery wire terminal

of the amplifier to the positive (+) battery

terminal.

1 Positive (+) terminal

2 Engine compartment

3 Vehicle interior

4 Fuse (40 A) × 2

5 Insert the O-ring rubber grommet into the

vehicle body.

6 Drill a 14 mm hole into the vehicle body.

Connect the wires to the terminal.

Fix the wires securely with the terminal

screws.

Section