Pioneer VSA-E03 Kullanım Talimatları Kılavuzu - Sayfa 20

Amplifikatör Pioneer VSA-E03 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Pioneer VSA-E03 48 sayfaları. Audio/video multichannel amplifier

Sayfayı Yazdır
Preparations

Setting Up the Remote Control

In addition to controlling the amplifier, the supplied remote control can operate your other components (DVD, MD, VCR,
TV, LD, CD, etc.). If your component(s) are listed in the "Preset Code List" on page 44, simply recall the corresponding
preset code. This remote control is factory set with the codes used to operate PIONEER components.
If you want to change the preset codes to operate components made by other manufacturers, follow the procedure
outlined below.
Recalling preset codes
The following steps show you how to recall preset codes for each MULTI CONTROL button. Once the preset code is
assigned, pressing the button will automatically set the remote to operate the respective component.
• Refer to "Preset Code List" on page 44 for the components and manufacturers available.
memo
• Refer to "Remote Controlling Other Components" on pages 35 to 40 and "Background Control of Other
Components" on page 41 for detailed explanations on how to operate your other components.
AMP
TV
FQ
+
ENTER
–
FQ
VOL
VOL
CHANNEL
MULTI CONTROL
DVD/LD
TV/SAT
CD
2
VCR 1
TV CONTROL
TUNER
VCR 2
AMP
MD/TAPE
DSP MODE
MIDNIGHT
1
2
3
4
CH.SELECT
TEST TONE
ATT SIG.SELECT
5
6
8
7
CH.LEVEL
EFFECT
9
0
+10
MEMU
CLASS
TV/VCR
FUNCTION
DIRECT
FL DIMMER
COMMANDER
MODE CHECK
SET UP
1
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
20
En
1
Press COMMANDER SET UP and
select the preset mode.
The MULTI CONTROL buttons on the remote control start to blink.
To cancel the preset mode
Press COMMANDER SET UP.
2
Press the MULTI CONTROL button for the component you
want to control.
Each button can be set to control one of the following components
DVD/LD
3
TV/SAT
CD
TUNER
MD/TAPE
VCR 1
VCR 2
Î
TV CONTROL
3
Point the remote control toward the component to be
controlled, enter the 3 digit setup code.
When a three digit code number is input, a power ON/OFF signal is
output from the remote control unit. If the power of the device turns
ON or OFF corresponding to this signal, it indicates that the device has
been set properly. If the power does not turn ON/OFF, input another
code.
Repeat steps 2 through 3 to assign preset codes for as many
components as necessary.
: DVD/LD player
: TV or Satellite tuner
: CD player
: Tuner
: MD recorder or Tape recorder
: Video deck
: Video deck
: TV or Cable TV tuner
1
at the same time to