Pioneer PD-S802 Servis Kılavuzu - Sayfa 27
CD Çalar Pioneer PD-S802 için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Pioneer PD-S802 36 sayfaları.
Sayfayı Yazdır
PD-54
1. Focus Offset Verification
@ Objective
Verify the DC offset for the focus error amp.
@ Symptom when out of | The model does not focus in and the RF signal is dirty.
adjustment
@ Measurement instru-
| Connect the oscilloscope to
@ Player state
Test mode, stopped
ment connections
TPI, Pin 6 (FCS. ERR)
(just the Power switch on)
[Settings] SmV/division
|®/diustmentlocation | None
10 ms/division
DC mode
@ Disc
None needed
[Procedure]
Verify the DC voltage at TP1, Pin 6 (FCS. ERR) is 0 + 50 mV.
Note : If the specified values cannot be obtained or no adjustment is possible by performing the
verifications or adjustments described in adjustment items 1 — 4, the pickup block may be defective.
2. Tracking Error Balance Verification
@ Objective
;
To verify that there is no variation in the sensitivity of the tracking photo diode.
@ Symptom when out of | Play does not start or track Search is impossible.
adjustment
@Measurementinstru-
| Connect the oscilloscope to
@ Player state
Test mode, focus and spindle servos
ment connections
TPI, Pin 2(TRK. ERR). This
closed and tracking servo open
connection may be via a low
pass filter.
@ Adjustment location
| None
[Settings]
50 mV/division
5 ms/division
DC mode
[Procedure]
1. Move the pickup to midway across the disc (R=35 mm) with the TRACK/MANUAL SEARCH FWD PP pp or
REV |<kI <k key.
2. Press the PGM (PROGRAM) key, then the PLAY [> key in that order to close the focus servo then the spindle servo.
3. Line up the bright line (ground) at the center of the oscilloscope screen and put the oscilloscope into DC mode.
4. Supposing that the positive amplitude of the tracking error signal at TP1, pin 2 (TRK ERR) is (A) and the negative
amplitude is (B), the following expression is satisfied.
When
ASB,
When
A<B,
When there is a DC
When there is no DC
component
component
35