Pioneer HTP-GS1 Kullanım Talimatları Kılavuzu - Sayfa 17
Hoparlör Sistemi Pioneer HTP-GS1 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Pioneer HTP-GS1 35 sayfaları. 5.1ch surround system
Sayfayı Yazdır
Getting started
3
If the receiver subwoofer is off, press
RECEIVER to turn the power on.
4
Press MCACC .
Try to be as quiet as possible after pressing MCACC. The
volume increases automatically and the system outputs
a series of test tones.
• To cancel Auto MCACC setup before it has finished,
press MCACC. The unit will continue to use the
previous settings.
• If the ambient noise level is too high, NOISY blinks in
the display for five seconds. To exit and check the
1
noise levels
, press MCACC, or to try again, press
ENTER when RETRY shows in the display.
• If you see an ERR MIC or ERR SP message in the
display, there may be a problem with your mic or the
speaker connections. To try again, press ENTER
2
when you see RETRY
When the MCACC setup is complete, the volume level
returns to normal, COMPLETE
Acoustic Calibration EQ is activated.
Note
1 • If the room environment is not optimal for the Auto MCACC setup (too much ambient noise, echo off the walls, obstacles blocking the speakers from
the microphone) the final settings may be incorrect. Check for household appliances (air conditioner, fridge, fan, etc.), that may be affecting the environ-
ment and switch them off if necessary.
• Some older TVs may interfere with the operation of the mic. If this seems to be happening, switch off the TV during Auto MCACC setup.
2 If this doesn't work, press MCACC, turn off the power, and check the problem indicated by the ERR message, then try the Auto MCACC setup again.
3 If COMPLETE doesn't appear, it is likely an error occurred during the setup. Please check all connections and try again.
4 See Listening with Acoustic Calibration EQ on page 20 to switch on/off Acoustic Calibration EQ.
3
shows in the display, and
4
04
17
En