Pioneer PDP-S11 Kullanım Talimatları Kılavuzu - Sayfa 4

Hoparlör Sistemi Pioneer PDP-S11 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Pioneer PDP-S11 21 sayfaları.

Sayfayı Yazdır

Pioneer PDP-S11 Kullanım Talimatları Kılavuzu

English

Route the speaker cords out of sight

from the front of the unit.

Route as shown in the diagram, using the wire

clamps (step 3) to secure the cords.

NOTE:

If you want to move the plasma display unit, make sure

that you remove the speaker first. In addition, do not

move the display holding on to the mounting fittings. This

can result in injury or damage to the unit.

CONNECTION TO A PLASMA

DISPLAY

Switch off the power of the plasma

display.

Use the supplied speaker cords to

connect the speaker outputs of the

plasma display to the speaker inputs on

the speaker system.

1. Remove the insulation

and twist the core ends

together.

(Speaker output terminals of the plasma display)

The polarity of the input terminals is plus ª for the

red terminal (the terminal on the right side in the

following figure) and minus · for the black terminal

(the terminal on the left side in the following figure).

• After connection to the terminals, pull lightly on

the cable to confirm that the tips of the cable are

properly connected to the terminals. An imperfect

connection can cause sound interruptions and

noise.

2. Push the lever, insert the

cable into the hole, and

release the lever.

ª terminal (red)

· terminal

(black)

Red

Black

To the ª terminal

To the· terminal

• When cable cores stick out and ª and · lines are

short-circuited, an excessive load will be applied to

the plasma display and the operation will stop or

trouble will be caused.

• Match the colors on the speaker cable with the

speaker terminals to ensure correct polarity. This

will result in correct stereo sound. Incorrect

polarity will result in poor, unfocused sound.

CABINET MAINTENANCE

• Use a polishing cloth or dry cloth to wipe off dust

and dirt.

• When the cabinet is very dirty, wipe with a soft

cloth moistened with water-diluted cleanser; then

wipe again with a dry cloth. Do not use furniture

wax or cleaners. They may damage the surface of

the cabinet.

• Never use thinner, benzine, insecticide sprays and

other chemicals on or near the cabinets, since

these will corrode the surfaces.

• When a chemical cloth is used, read the cautions

for the chemical cloth carefully.

SPECIFICATIONS

Cabinet : Enclosed type

Used speakers (two-way system) :

Woofer (for low tones) .............................. Oval cone type

Tweeter (for high tones) ...................... 2.5 cm dome type

Nominal impedance ..................................................... 8 Ω

Frequency Range ..................................... 60 to 20,000 Hz

Sensitivity ................................ 82 dB/W (at 1 m distance)

Permissible input :

Max. input ................................................................. 12 W

Rated input ............................................................. 2.5 W

Crossover frequency ................................................ 3 kHz

External Dimensions ..... 1070 (W) x 74 (H) x 102 (D) mm

Weight ..................................................................... 2.7 kg

Accessory parts

Speaker cable .................................................................. 2

Wire clamp ...................................................................... 2

Flat countersunk head screw .......................................... 2

Hexagon socket head screw ........................................... 2

Mounting tool (Hex wrench) ........................................... 1

Speaker mounting fittings ............................................... 2

Operating Instructions .................................................... 1

NOTE:

Specifications and design subject to possible modification

without notice, due to improvements.

Published by Pioneer Corporation.