Pioneer S-L9-A-LRW Kullanım Talimatı - Sayfa 8
Hoparlör Sistemi Pioneer S-L9-A-LRW için çevrimiçi göz atın veya pdf Kullanım Talimatı indirin. Pioneer S-L9-A-LRW 48 sayfaları. Stereo cd receiver; speaker system; stereo cassette deck
Ayrıca Pioneer S-L9-A-LRW için: Servis Kılavuzu (3 sayfalar), Servis Kılavuzu (3 sayfalar)
Sayfayı Yazdır
2 Installing and Connecting Up
Connecting Up the System
Display cable
Ribbon cable
System connections
Ribbon cables
IMPORTANT: Never connect or
disconnect the system ribbon cables
while the power plug is connected to
the wall outlet. Doing so may damage
the unit.
To insert, hold the connector and push
firmly into the socket until you hear it
click home.
To remove, hold the connector
securely on either side with thumb and
forefinger and pull out from the socket.
8
Important: Before making or changing any rear
panel connections, make sure that all the compo-
nents are switched off and unplugged from the power
supply.
Display unit
The CD receiver is the central component of the
system: everything else connects to it. The diagram
left shows the tape deck connected to the CD receiver,
without the optional MD recorder or CD recorder. (If
you bought either/both of these, see their respective
CD receiver
instruction manuals for details of connecting them
to the rest of the system.)
1 Connect the display cable between the CD
Tape deck
2 If you also have the tape deck:
It is possible to wall-mount the display unit using
two screws (not supplied) securely fastened to a wall.
Line the screws up with the holes on the rear side of
the unit and hang the unit on the wall.
Note: Pioneer bears no responsibility for
accidents resulting from faulty assembly or
installation, insufficient mounting strength of
walls or other building fixtures, misuse or
natural disasters.
To use the remote and display as a single unit,
connect the two as shown below. When correctly
connected the four larger buttons light up blue.
1
2
receiver and display unit, taking care to connect
the L-shaped connector to the display unit.
Connect it up to the CD receiver using the ribbon
cable attached to the rear of the tape deck. (See
Ribbon cables, left, for important information
on connecting/disconnecting these.)
Screw holes for
wall-mounting
3