3Com EtherLink 3C509B Hızlı Kılavuz - Sayfa 4

Ağ Kartı 3Com EtherLink 3C509B için çevrimiçi göz atın veya pdf Hızlı Kılavuz indirin. 3Com EtherLink 3C509B 8 sayfaları. Isa network interface card

6 Carefully insert the NIC into the slot; press ﬁrmly with

steady pressure to ensure that the NIC is fully seated in

the slot.

When the NIC is correctly inserted in the slot, the NIC backplate is

ﬂush with the PC backplate.

7 Secure the NIC with the backplate screw.

8 Replace the PC cover. Reinsert and tighten the cover screws.

9 Reconnect all power and peripheral cables.

10 Turn the power on and boot Windows 95.

11 Connect the NIC port to the network cable.

Make sure the network cable is connected to the network.

The next step is to install the network driver.

Installing the Network Driver

This section describes how to set up your system environment

when installing the NIC in a Windows 95 PC that has a Plug and

Play BIOS installed.

Follow these steps to conﬁgure the NIC:

1 Turn the power on and boot Windows 95.

The New Hardware Found screen appears. The Update Device

Driver Wizard then displays the screen shown in Figure 2.

Figure 2 Update Device Driver Wizard Screen