Ariston 65 DRY Manuel - Sayfa 27
Su Isıtıcı Ariston 65 DRY için çevrimiçi göz atın veya pdf Manuel indirin. Ariston 65 DRY 41 sayfaları.
Sayfayı YazdırEnable the function "Demand Response", through which, the water heater will turn on and off for a very
limited time in order to balance the consumption on the network. This action is performed simultaneous-
ly on thousands of water heaters in the houses of each customer, allowing a real energy revolution that
starts from your home.
TECHNICAL CHARACTERISTICS
Installation type
Certification
Operating temperature
Storage temperature
Operating Humidity
IN/OUT
Wi-Fi standard
Power consumption
Installation place
Weight
The device has been evaluated to meet general RF exposure requirements and can be used in porta-
ble exposure conditions without restriction. The product is in compliance with Directives 2014/53/EU &
2011/65/EU.
The full text of the EU declaration of conformity is available at the following internet address:
www.aristongroup.com/en/download-area.
This product, excluding horizontal models (Table 1), is a device that must be installed vertically in
order to operate correctly. Once installation is complete, and before any water is added or the power
supply is connected, use a measuring instrument (i.e. a spirit level) to check that the device has been
installed perfectly vertical.
The appliance heats water to a temperature below boiling point. It must be linked up to a mains water
supply according to the appliance performance levels and capacity.
Before connecting the appliance, it is first necessary to:
- Check whether the characteristics (please refer to the data plate) meet the customer's requirements.
- Make sure the installation conforms to the IP degree (of protection against the penetration of liquids)
of the appliance according to the applicable norms in force.
- Read the instructions provided on the packaging label and on the appliance data plate.
This appliance was designed to be installed only inside buildings in compliance with the applicable
norms in force. Furthermore, installers are requested to keep to the following advice in the presence of:
- Humidity: do not install the appliance in closed (unventilated) and damp rooms.
- Frost: do not install the appliance in areas where the temperature may drop critically and there may
be a risk that ice may form.
- Sunlight: ndo not expose the appliance to direct sunrays, even in the presence of windows.
- Dust/vapours/gas: do not install the appliance in the presence of particularly dangerous substances
such as acidic vapours, dust or those saturated with gas.
- Electrical discharges: do not install the appliance directly on electrical supplies that aren't protected
against sudden voltage jumps.
POWER METER SMART SWITCH
INSTALLING NORMS (for the installer)
Screws intallation N and L (Also match with DR rail tray)
CE, REACH, RoHS, LVD, RED
0° ÷ +40°C
-15° ÷ +80°C
5% ÷ 95% RH Not condensing
220-240Vac, 50Hz, 13A, 3000W
IEE 802.11 b/g/n 2.4GHz
< 1 W
indoor
50 g
27 / EN