Aeotec AEOEZW120 Kullanıcı Kılavuzu - Sayfa 3

Aksesuarlar Aeotec AEOEZW120 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Aeotec AEOEZW120 7 sayfaları.

Important safety information.

Please read this and other device guides carefully. Failure to follow the recommendations set forth by Aeotec Limited

may be dangerous or cause a violation of the law. The manufacturer, importer, distributor, and / or reseller will not be

held responsible for any loss or damage resulting from not following any instructions in this guide or in other materials.

Door / Window Sensor Gen5 is intended for indoor use in dry locations only. Do not use in damp, moist, and / or wet

locations.

Contains small parts; keep away from children.

The installation of your Door Window Sensor has two major steps: the Main Sensor and the Magnet. Your Door

Window Sensor will use wireless technology to talk to your Z-Wave network once paired to your Z-Wave network.

Selecting where you'll place your Door/Window Sensor in your home is just as important as the actual affixing it to the

surface. Whether it's for security or intelligence purposes, your sensor: With your mounting plates prepared to hold

each component of your sensor, it's time to add it to your Z-Wave network. With your sensor added to your Z-Wave

network, it's now time to insert each main part of your sensor into the corresponding sensor plate.

1. Should be affixed indoors and away from sources of moisture.

2. Placed within 30 meters of another Z-Wave device that is either a gateway or not powered by batteries.

3. The magnet and the main sensor must be less than 2cm apart. Main sensor must be affixed to the door or

window and the magnet must be affixed to the frame. The magnet and the main sensor must separate when the

door or window is opened.

4. Should not be mounted on a metal frame.

Affix your Sensor plates to a surface. The Mounting plates can be affixed using screws or double-sided tape. If you

are using screws, attach both mounting plates to the respective surface using the two 20mm screws provided.