Aeotec Water Sensor 7 Pro Kullanıcı Kılavuzu - Sayfa 8

Aksesuarlar Aeotec Water Sensor 7 Pro için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Aeotec Water Sensor 7 Pro 13 sayfaları. Water sensor
Ayrıca Aeotec Water Sensor 7 Pro için: Manuel (3 sayfalar), Hızlı Başlangıç Kılavuzu (8 sayfalar), Kullanıcı Kılavuzu (9 sayfalar), Kullanıcı Kılavuzu (14 sayfalar), Kullanıcı Kılavuzu (9 sayfalar)

3.7

How to factory reset

This device also allows to be reset without any involvement of a Z-Wave controller. This procedure should only be used

when the primary controller is inoperable.

Once Cover is removed and the tamper switch is tripped, push the tamper for 5 seconds until the RED LED blinks once.

Then release tamper and push it again for 5 seconds while the RED LED is blinking until the GREEN LED blinks once.

3.8

The product contains batteries. Please remove the batteries when the device is not used. Do not mix batteries of

different charging level or different brands.

3.9

Once installed the sensor will report sensor status changes to a central Z-Wave controller using notification commands.

Additionally, the sensor can directly control other devices using association group 2.The device is protected by a tamper

switch.

Link testing

When activated by configuration parameter #5 the device can perform a link test with device No.1. Double-clicking the

tamper will start the process. As a result, the GREEN LED will blink two times in case of success and the RED LED will

blink two times in case of failure.

AEOTEC User Manual

Page 5