Ariston PRIMO HE ITI 300 Kurulum ve Kullanım Kılavuzu için Talimatlar - Sayfa 14

Su Isıtıcı Ariston PRIMO HE ITI 300 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu için Talimatlar indirin. Ariston PRIMO HE ITI 300 24 sayfaları. Unvented hot water storage cylinders
Ayrıca Ariston PRIMO HE ITI 300 için: Kurulum, Servis ve Çalıştırma Talimatları (34 sayfalar)

Sayfayı Yazdır

www.tradeplumbing.co.uk Call Sales On 08708034288

2.11

LECTRICAL

IAGRAM

www.tradeplumbing.co.uk Call Sales On 08708034288

Should the Economy 7 system not to be used, a separate 13 amp supply to

each element will be required. Through a double pole fused isolating switch

having a contact gap of at least 3mm on each pole.The immersion heater

shall be installed with 85°C rubber insulated HOFR-sheathed flexible cable

complying with Table 8 of BS 6141: 1991. Make the connection(s) to the

immersion heater(s) as per F

litre models consult the wiring diagram on the reverse of the inspection

panel.

Single Element

. 2.12

. 2.13

The thermostat(s) on the immersion heater(s) should be adjusted to trip at

60°C. This is the ideal temperature to prolong element life in hard water

areas. Scale on the sheath builds up more rapidly at temperatures above

this causing the element to overheat and premature failure can occur. Higher

temperatures without additional controls would result in scalding.

In addition to the thermostat the thermal cut-out will switch power off to the

element should the thermostat malfunction, causing an excessive rise in

water temperature. The thermal cut-out can be reset manually after the fault

has been corrected.

. 2.12 and F

. 2.13. For High Capacity 500

THERMAL

THERMOSTAT

CUT-OUT

THERMAL

THERMOSTAT

CUT-OUT

THERMAL

THERMOSTAT

CUT-OUT

ELEMENT

3 kW

240V~

DAY ELEMENT

3 kW 240V~

NIGHT ELEMENT

3 kW 240V~

ECONOMY 7