Aeotec ZWA019 Kullanıcı Kılavuzu - Sayfa 7
Aksesuarlar Aeotec ZWA019 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Aeotec ZWA019 9 sayfaları. Water sensor
Ayrıca Aeotec ZWA019 için: Manuel (3 sayfalar), Kullanıcı Kılavuzu (13 sayfalar), Kullanıcı Kılavuzu (9 sayfalar)
Sayfayı Yazdır
Parameter: 3
Size: 1 Byte
Default Value: 7
Description:
This parameter defines when the red LED will indicate events. Disabling all indications may extend battery life.
(values 1 + 2 + 4 summarized)
0 - No indications
1 - Water Leakage Status Change
2 - Wake Up (1 x click)
4 - Device tampering
4. Range test after double click
Parameter: 4
Size: 1 Byte
Default Value: 0
Description:
Allows to enable the activation of a Z-Wave range test with double clicking the tamper switch.
0 - disabled
1 - enabled
5. 2nd Association Group Trigger
Parameter: 5
Size: 1 Byte
Default Value: 0
Description:
This parameter defines the status of the water leakage that causes sending a BASIC command to all devices of
Association Group 2.
0 - Switch after Water Leakage Start and Stop
1 - Switch after Water Leakage Start
2 - Switch after Water Leakage Stop
6. Command Sent to Devices of Association Group 2
Parameter: 6
Size: 1 Byte
Default Value: 255
Description:
This parameter defines which commands is sent to 2nd Association Group
0 - On
1 - Off
2 - On and Off
7. BASIC command value sent to 2nd Association Group on On event
Parameter: 7
Size: 1 Byte
Default Value: 255
Description:
This is the BASIC command value sent in case of On even
0 - 99 - Value
255 - On
8. BASIC command value sent to 2nd Association Group on Off event
Parameter: 8