Aeotec AEOEZW132 Manuel - Sayfa 3

Anahtar Aeotec AEOEZW132 için çevrimiçi göz atın veya pdf Manuel indirin. Aeotec AEOEZW132 10 sayfaları. Dual nano switch with power metering

Sayfayı Yazdır

7-11-2020

2. If inclusion still fails, check if both devices use the same frequency.

3. Remove all dead devices from associations. Otherwise you will see severe delays.

4. Never use sleeping battery devices without a central controller.

5. Dont poll FLIRS devices.

6. Make sure to have enough mains powered device to benefit from the meshing

Association - one device controls an other device

Z-Wave devices control other Z-Wave devices. The relationship between one device controlling another device is called association. In order to control a different

device, the controlling device needs to maintain a list of devices that will receive controlling commands. These lists are called association groups and they are

always related to certain events (e.g. button pressed, sensor triggers, ...). In case the event happens all devices stored in the respective association group will

receive the same wireless command wireless command, typically a 'Basic Set' Command.

Association Groups:

Group Number

Configuration Parameters

Z-Wave products are supposed to work out of the box after inclusion, however certain configuration can adapt the function better to user needs or unlock further

enhanced features.

IMPORTANT: Controllers may only allow configuring signed values. In order to set values in the range 128 ... 255 the value sent in the application shall be the

desired value minus 256. For example: To set a parameter to 200 it may be needed to set a value of 200 minus 256 = minus 56. In case of a two byte value the

same logic applies: Values greater than 32768 may needed to be given as negative values too.

Parameter 3: Current Overload Protection.

Output Load will be turned off automatically after 30 seconds and if the current overrun 1.5A.

Size: 1 Byte, Default Value: 1

Setting

Parameter 4: Overheat protection.

Output Load will be turned off automatically after 30 seconds and if the temperature of product inside exceeds 100 u2103.

Size: 1 Byte, Default Value: 0

Setting

Parameter 20: Configure the output status after re-power on it.

Configure the output status after re-power on it.

Size: 1 Byte, Default Value: 0

Setting

manual.zwave.eu/backend/make.php?lang=en&sku=AEOEZW132

Maximum

Description

Nodes

Z-Wave Plus Lifeline.When the load state of Dual Nano Switch (turn on/off the load) is changed, the

Hail CC and Basic Report (configured by parameter 80) can be sent to the associated nodes in this

group.

Forward the Basic Set, Switch All, Scene Activation Set to associated nodes in Group 2 when the

Dual Nano Switch receives the Basic Set, Switch All, Scene Activation Set commands from main

controller. (E.g. Send/forward Basic Set to control the other nodes in association Group 2)

Send Basic Set (configured by parameter 81 ) to the associated nodes in Group 3 when the

external switch S1 is operated.Note: The Switch Mode of external switch S1 should be identified

successfully, which means that the value of Configuration parameter 120 should be non-zero, then

the Basic Set can be sent to the associated nodes in Group 3 via triggering the S1 switch.

Send Basic Set (configured by parameter 82) to the associated nodes in Group 4 when the external

switch S2 is operated.Note: The Switch Mode of external switch S2 should be identified

successfully, which means that the value of Configuration parameter 121 should be non-zero, then

the Basic Set can be sent to the associated nodes in Group 3 via triggering the S2 switch.

Description

Disable

Enable

Description

Disable

Enable

Description

Last status

Always on

Always off

3/10