Aeotec ZW116 Manuel - Sayfa 6
Anahtar Aeotec ZW116 için çevrimiçi göz atın veya pdf Manuel indirin. Aeotec ZW116 13 sayfaları. Single nano switch with measuring
Ayrıca Aeotec ZW116 için: Kullanıcı Kılavuzu (18 sayfalar)
Sayfayı Yazdır
Association Groups:
Group Number
1
2
3
4
Configuration Parameters
Z-Wave products are supposed to work out of the box after inclusion, however certain configuration can adapt
the function better to user needs or unlock further enhanced features.
IMPORTANT: Controllers may only allow configuring signed values. In order to set values in the range 128 ...
255 the value sent in the application shall be the desired value minus 256. For example: To set a parameter to
200 it may be needed to set a value of 200 minus 256 = minus 56. In case of a two byte value the same logic
applies: Values greater than 32768 may needed to be given as negative values too.
Parameter 3: Current Overload Protection.
Over current protection. Output load will be closed after 30 seconds if the current exceeds (US: 15.5A, AU or
EU: 10.5A)
Size: 1 Byte, Default Value: 1
Setting
0
1
Parameter 4: Overheat protection.
Output Load will be turned off automatically after 30 seconds and if the temperature of product inside exceeds
100°C.
Size: 1 Byte, Default Value: 0
Setting
0
1
Parameter 20: Configure the output status after re-power on it.
Configure the output status after re-power on it.
Size: 1 Byte, Default Value: 0
Setting
0
1
2
Maximum
Description
Nodes
5
Z-Wave Plus Lifeline.When the load state of Nano Switch (on/off) is changed, the
Hail CC, Switch Multilevel Report and Basic Report (configured by parameter 80)
can be sent to the associated nodes in this group.
5
Forward the Basic Set, Switch All, Scene Activation Set to associated nodes in
Group 2 when the Nano Switch receives the Basic Set, Switch All, Scene Activation
Set commands from main controller.
5
Send Basic Set (configured by parameter 82) to the associated nodes in Group 3
when the external switch S1 is operated
5
Send Basic Set (configured by parameter 82) to the associated nodes in Group 4
when the external switch S2 is operated
Description
Disable
Enable
Description
Disable
Enable
Description
Last status
Always on
Always off