Aeotec DSB28-ZWAU Kullanıcı Kılavuzu - Sayfa 6

Ölçüm Cihazları Aeotec DSB28-ZWAU için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Aeotec DSB28-ZWAU 8 sayfaları. Home energy meter g2

23-2-2017

1. Put your primary Z-Wave controller, usually a gateway or hub, into inclusion mode. If you are not sure how to do this,

please refer to your controller's user manual.

2. Press the Action Button on your HEM. If it has been successfully linked to your network, its LED will remain

illuminated. If the linking was unsuccessful, your HEM's LED will continue to blink.

The installation of your Home Energy Meter is now complete. The next step is to set up your Home Energy Meter within

the interface of your primary Z-Wave controller. This will allow you to visualize and utilize the energy consumption data

that your meter collects.

Your Home Energy Meter can report wattage energy usage or KWH energy usage to your primary controller. As each

controller is diﬀerent, please refer to your controller's user manual for further information on monitoring and visualizing this

data. The Z-Wave commands supporting energy monitoring are the Meter Command Classes.

Advanced functions.

Removing your meter from a Z-Wave network.

Your Home Energy Meter (HEM) can be removed from your Z-Wave network at any time. You'll need to use your Z-Wave

network's primary to do this.

1. Put your main controller into its device removal mode. If you are unsure how to do this, please refer to your controller's

user manual.

2. Press the Action Button on your HEM. If it has been successfully removed from your network, its LED will blink. If the

removal was unsuccessful, its LED will be solid and it will be then repeated again.

Resetting your Home Energy Meter.

Your Home Energy Meter can be reset to default factory settings with ease.

1. Press and hold the Action Button for 10 seconds.

2. If successful, the LED on the HEM should begin to blink slowly.

Associating your Home Energy Meter to Report Automatically.

Your Home Energy Meter can send Wattage and KWH usage reports to associated devices. To enable this, please refer

to your controller's manual on how to conﬁgure settings on Z-Wave devices linked to your controller. Initially, the meter is

set up to report Watt and KWH reports.

Some gateways/controllers will automatically conﬁgure devices enabling you to take full advantage of the Home Energy

Meter's features. Others may not perform any automatic conﬁguration. In such a case you can choose to manually

conﬁgure your meter to output the data that you wish to view.

Setting automatic report ﬂags.

Parameter 101-103 [4 byte dec] can be conﬁgured through your gateway in case that the default settings of your meter

are not what you desire.

You may also download the conﬁguration sheet that can be used to easily choose and automatically calculate the value

that you are looking for:

https://aeotec.freshdesk.com/support/solutions/articles/6000166671-home-energy-meter-g2-user-manual-

Home Energy Meter G2 user manual. : Aeotec by Aeon Labs

6/8