Ariston MS5844IXAAUS Manuel - Sayfa 8
Fırın Ariston MS5844IXAAUS için çevrimiçi göz atın veya pdf Manuel indirin. Ariston MS5844IXAAUS 14 sayfaları.
OPTIONS
ALARM TONE
To set the alarm tone, long press button
To select the desired tone, press buttons
press the time button to confirm.
BRIGHTNESS
To set the brightness of display, long press button
To select the desired tone, press buttons
press the time button to confirm.
KEY LOCK
The key lock will be active within 30 seconds after the
last button pression. The icon
To deactivate it, long press the time button.
4. PREHEATING
Once the function has been activated, the LED
thermostat will switch on signalling that the preheating
process has begun.
CLEANING AND MAINTENANCE
Make sure that the oven has
cooled down before carrying out
any maintenance or cleaning.
Do not use steam cleaners.
EXTERIOR SURFACES
• Clean the surfaces with a damp microfibre cloth. If
they are very dirty, add a few drops of pH-neutral
detergent. Finish off with a dry cloth.
• Do not use corrosive or abrasive detergents. If any
of these products inadvertently comes into contact
with the surfaces of the appliance, clean
immediately with a damp microfibre cloth.
INTERIOR SURFACES
• After every use, leave the oven to cool and then
clean it, preferably while it is still warm, to remove
any deposits or stains caused by food residues. To
dry any condensation that has formed as a result of
cooking foods with a high water content, let the
oven to cool completely and then wipe it with a cloth
or sponge.
• Clean the glass in the door with a suitable liquid
detergent.
• The oven door can be removed to facilitate
cleaning.
ACCESSORIES
Soak the accessories in a washing-up liquid solution
after use, handling them with oven gloves if they are
still hot. Food residues can be removed using a
washing-up brush or a sponge.
REPLACING THE LAMP
• Disconnect the oven from the power supply.
• Unscrew the cover from the lamp, replace the bulb
and screw the cover back on the lamp.
• Reconnect the oven to the power supply.
8
.
or
, then
.
or
, then
will appear on display.
Do not use wire wool, abrasive
scourers or abrasive/corrosive
cleaning agents, as these could
damage the surfaces of the
appliance.
At the end of this process, the LED thermostat
switches off indicating that the oven has reached the
set temperature: at this point, place the food inside and
proceed with cooking.
Please note: placing the food in the oven before preheating
has finished may have an adverse effect on the final cooking
result.
COOLING SYSTEM
The cooling fan may switch itself on every so often
during cooking in order to reduce energy consumption.
Once cooking is complete and the oven has been
switched off, the cooling fan may continue to run for a
certain period of time.
Wear protective gloves.
The oven must be disconnected
from the mains before carrying
out any kind of maintenance work.
Please note: Only use 15-25 W/220-240 V type G9, T300°C
halogen bulbs. The bulb used in the product is specifically
designed for domestic appliances and is not suitable for
general room lighting within the home (EC Regulation
244/2009).
Light bulbs are available from our After-Sales Service.
When using halogen bulbs, do not handle them with your
bare hands as your fingerprints could cause damage. Do not
use the oven until the lamp cover has been refitted.
REMOVING AND REFITTING THE DOOR
To remove the door, open it fully and lower the catches
until they are in the unlock position.
Set the hinge lock to the widest angle. Adjust both
hinges connecting oven door to the oven to the same
position.