Ariston SD1521 Hizmet Bilgileri - Sayfa 11

Buzdolabı Ariston SD1521 için çevrimiçi göz atın veya pdf Hizmet Bilgileri indirin. Ariston SD1521 15 sayfaları. Freestanding larder fridges

Indesit

Company

REVERSING THE DOORS (All models except SD1722J)

Fig 1: Removing the Door and Top Hinge fittings

Open the door and ease the hinge cover strip out from above the door seal; starting from the area

nearest to the hinge. Also remove the plastic plug button above the hinge pin at the top of the door.

Remove the hinge pin, whilst supporting the door.

Lift the door from the lower hinge.

Remove the hinge arm and bush, affixed at the top of the inner door and transfer to the left hand

side.

Fig 2: Top Hinge, Blanking Plates and transfer to left hand side

Remove the plastic insert at each end of the control panel.

Remove the top hinge. Invert the top hinge and transfer to the other side. Insert the blanking plates

in the control panel but in reversed positions to the originals.

Fig 3: Plinth, Bottom Hinge and Fixing Plate removal and transfer to left hand side

Remove the screws (T20 Torx) securing the plinth/kick plate.

Remove the bottom hinge and its fixing plate. Transfer them to the other side. Remove the hinge pin

from the left hand side of the hinge and retain until the plinth is in place.

Insert the plinth blanking plate (supplied with the appliance) to the right hand side slot. Using a

suitable tool push-out the similar size moulded area on the left hand side. Refit the plinth and lower

hinge pin, using the hole on the left hand side.

Fig 4: Grab Handle, Blanking Plugs and bottom Bush/Closure Aid

Remove the grab handle from the left hand side and the plug buttons from the right hand side and

transfer them to the opposite sides.

Remove the right hand bush from the bottom of the door and retain for right hand hinging. Fit the left

hand bush/closure aid supplied with the appliance to the left hand side and secure with the screw.

Fig 5: Refitting the Door and Hinge Cover Strip

Lower the door onto the bottom hinge pin and manoeuvre it into position to locate the top hinge and

hinge arm with bush. Replace the hinge pin ensuring that it is tight.

Replace the long hinge cover strip and the plug button at the top of the door.

Check that the door closes properly and that the interior light switch operates and that the door is

sealing properly.

Service Manual UK

English

11 of 15