Ariston EVK6 Series Kullanım Kılavuzu - Sayfa 11

Hob Ariston EVK6 Series için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Ariston EVK6 Series 16 sayfaları. Electric built-in cooking hob

Connecting the appliance to the power mains

Important warnings

• The appliance may only be connected by an authorized skilled technician.

• Electric system protection should comply with all relevant regulations.

• The connection clips can be accessed when the connection clip covers are opened / removed.

• Before connecting the appliance, make sure the voltage indicated on the rating plate is

consistent with the voltage in your home circuit.

• The rating plate with basic information is attached on the lower side of the hob.

• The electric circuit should also include an omnipolar switch that will separate the appliance from

the mains, if required, with at least 3 mm of distance between contacts. Suitable devices include

fuses, current protection switches, etc.

• The connection should be selected according to the installation possibilities with regard to

current and fuses.

• Given the protection from the risk of ﬁ re, appliances of this type may be installed in a worktop

next to a piece of kitchen furniture that is taller than the appliance (when installed); however,

in this case, a kitchen furniture element must be installed on the other side, adjacent to the

appliance.

• The current conducting and isolated parts must be protected from any possibility of direct

contact.

Connection diagram

WARNING!

• Before any intervention, disconnect the appliance from the

power mains. Connect the appliance in compliance with the

electric connections diagram supplied; make sure the relevant

network voltage is observed! The ground wire (PE) should be

connected to the clip indicated by the earthing symbol.

• The mains cable should be fed through the fastening clip

which protects it from being accidentally pulled out.

• After connecting the appliance, turn on all cooking zones /

heaters for approximately three minutes to make sure they are

operating correctly.

• Incorrect connection may destroy parts of the appliance,

making the warranty void.

• Before connecting the appliance, make sure the voltage

indicated on the rating plate is consistent with the voltage

in your home network. Connection voltage (230 V through

N) should be checked by a qualiﬁ ed technician using a

corresponding measuring device!

• Connection cable on the back of the appliance should be led in

such way that it does not touch the appliance back wall, as this

part will get very hot during operation.