Acom 1006 Kullanım Kılavuzu - Sayfa 6

Amplifikatör Acom 1006 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Acom 1006 20 sayfaları. 6 m linear amplifier

liquids. AVOID placing the amplifier in excessively dusty environments or in direct sunlight. DO NOT

OBSTRUCT AIR INTAKE (rear panel) and EXHAUST (top cover) areas of the amplifier. Keep a minimum

distance of 10cm (4 inches) to the intake and 50cm (20 inches) to the exhaust.

W A R N I N G

Do not undertake on your own repairs or changes in hardware or software of the amplifier. Otherwise you

may endanger your or other's health and life or damage the amplifier and the equipment connected with it,

not covered by warranty. The manufacturer is not liable for another's actions and responsibility shall be

assumed by the doer.

C A U T I O N

Тo avoid damage (not covered under warranty), please read the Section 2 (Installation) of this operating manual

carefully. If you have any doubts about the installation, operation or safety of the amplifier please consult your dealer.

2. INSTALLATION

N O T E

Before you start to install the amplifier, thoroughly read this manual. First, carefully inspect the cardboard

carton and its contents for physical damage. If damage is noticed, notify your dealer immediately. Delay may

infringe carrier's warranty conditions. Keep all packing for possible future transportation!

C A U T I O N

To avoid damage (not covered under warranty), check carefully if the voltage for which the amplifier is set

corresponds to your mains nominal voltage.

When supplied, normally the amplifier is set for a nominal mains voltage of 240V. There might be exceptions

in cases of special delivery and then the voltage set is noted in the Table of Individual Data (Table 2-1).

AMP s/n

Tube s/n

Voltage Selector

If your mains has a different nominal voltage, it will be necessary for you to contact your dealer. Means is

provided in the amplifier to reconnect it for 100, 110, 120, 200, 210, 220, 230, and 240 VAC nominal voltage.

C A U T I O N

The weight of the unit is about 22kg, which should preferably be handled by two persons.

Position the amplifier near the place where it will be used. You'll need an easy access to the command knobs

and indicator area, as well as to the rear panel cabling.

Table 2-1. The ACOM 1006 Individual Data

VAC