Whirlpool 220-240~volt Kurulum ve Kullanım Kılavuzu için Talimatlar - Sayfa 6

Yıkayıcı Whirlpool 220-240~volt için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu için Talimatlar indirin. Whirlpool 220-240~volt 18 sayfaları. Whirlpool washer lnstallation instructions 220/240-volt, 60-hz models
Ayrıca Whirlpool 220-240~volt için: Kurulum Talimatları (5 sayfalar)

Sayfayı Yazdır

Wheel bracket

Self-tapping

assembly

screw (pivot)

4. Place the other two corner posts on the floor to the

side of the compactor. Grasp the sides of the compac-

tor cabinet and put compactor on its side on top of the

corner posts. Remove the shipping base from the

bottom of compactor.

5. The rear wheels are preset for a cabinet opening

height of 86.4 cm (Position "A"). To adjust for other

heights, loosen screw just enough to clear stud from

hole in Position "A." Move the rear wheel and stud to

Position "B" or "C" as needed.

Position B: 87.4 cm

Position C: 88.1 cm

Tighten screw. Repeat for other rear wheel.

6. Place level inside on the floor of the cabinet. Check

that the compactor is level from front to back and

side to side. Adjust the leveling legs until the

compactor is level.

7. Move the compactor close to its final position.

Plug the power supply cable into a properly earthed

receptacle.

IMPORTANT:

When moving or lifting the compactor,

use gloves to protect and cushion your hands.

8. Carefully move compactor into its final position. Check

that compactor is still level. (See Step 6.)

continued

on next page