Whirlpool 6528 Kullanım Kılavuzu - Sayfa 12

Yıkayıcı Whirlpool 6528 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Whirlpool 6528 14 sayfaları. 7kg, 1200rpm, 6th sense eco washing machine awo/d 6528 wp

Whirlpool 6528 Kullanım Kılavuzu
Red indication
lights up
(if fitted on your
machine)
"Service"
Indication on
time display
(if fitted on your
machine)
from "F02" to "F35"
"Electrical module fault"
(except "F09")
Select and start the "Drain" programme or push the
"Reset" button for at least 3 seconds.
from "F40" to "F43"
"Electrical module fault"
Make sure that the water tap is open. If yes:
• Switch the washing machine off or turn the
• Select and start the "Drain" programme or push
"F09"
"Water level too high" (after programme
cancellation or false operating). Switch off the
appliance (by pressing the "On/Off" button or by
turning the programme selector to the "Off/O"
position - depending on the model) and then switch
it on again, select the programme "Drain" and start
within 15 sec.
"FA"
"Waterstop fault"
Switch off the appliance the appliance (by pressing
the "On/Off" button or by turning the programme
selector to the "Off/O" position - depending on the
model), pull out mains plug and turn the water tap
off. Tilt the appliance forward carefully to allow
collected water to flow out from the bottom. Then:
• Plug in the appliance again.
• Turn the water tap on (if water immediately flows
• Select and start the desired programme again.
"Fod"
"Overfoaming"
Too much foam interrupted the wash programme.
• Select and start the "Rinse & Spin" programme.
• Afterwards select and start the desired
If any of the faults described above persist,
unplug the appliance, turn off the water tap
and contact our After-Sales Service (see next
chapter).
GB 12
Description
Causes
Solutions
programme selector to the "Off/O" position; then
switch it on again or turn the programme selector
to a wash programme. If there is still a failure:
the "Reset" button for at least 3 seconds.
into the appliance without the appliance being
started, there is a failure; turn off the tap and notify
the After-Sales Service).
programme again, using less detergent.