Whirlpool 6AWTW5550XW1 Kullanım ve Bakım Kılavuzu - Sayfa 18

Yıkayıcı Whirlpool 6AWTW5550XW1 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. Whirlpool 6AWTW5550XW1 20 sayfaları. Top-loading high efficiency low-water washer

Sayfayı Yazdır

TROUBLESHOOTING

First try the solutions suggested here for assistance and to possibly avoid a service call.

If you experience

Washer not performing as expected (cont.)

Incorrect dispenser

operation

Fabric damage

No sound when

buttons are pressed

Odors

Estimated Time

Remaining is

not correct

Possible Causes

Clogged dispensers or laundry

products dispensing too soon.

Residual powder in dispenser.

Sharp items were in pockets during

wash cycle.

Strings and straps could have tangled.

Items may have been damaged before

washing.

Fabric damage can occur in a

tightly packed load.

Liquid chlorine bleach may have been

added incorrectly.

Garment care instructions may not

have been followed.

Button sounds are turned off.

Monthly maintenance not done as

recommended.

Using wrong or too much detergent.

Excess suds caused by not

using HE detergent or using too

much detergent.

Vibration or unbalanced.

Do not overfill dispenser, which causes immediate dispensing.

Always select Fabric Softener option to ensure proper dispensing.

Load dispensers before starting a cycle.

Homes with low water pressure may result in residual powder in the

dispenser. To avoid, select a warmer wash temperature if possible,

depending on your load, or use liquid HE detergent.

Use only liquid chlorine bleach in the bleach dispenser.

In wash water temperatures colder than 15.6° C (60° F), some

detergents do not dissolve well. Soils may be difficult to remove.

To avoid, select a warmer wash temperature if possible, depending

on your load, or use liquid HE detergent.

Empty pockets, zip zippers, and snap or hook fasteners before

washing to avoid snags and tears.

Tie all strings and straps before starting wash load.

Mend rips and broken threads in seams before washing.

Load garments in loose heaps evenly around the basket wall.

Load with dry items only.

Use cycle designed for the fabrics being washed.

Add only 1 or 2 garments after washer is started.

Do not pour liquid chlorine bleach directly onto load. Wipe up

bleach spills.

Undiluted bleach will damage fabrics. Do not use more than

recommended by manufacturer.

Do not place load items on top of bleach dispenser when

loading and unloading washer.

Always read and follow garment manufacturer's care label

instructions.

Button sounds can be turned on or off by pressing and holding

Cycle Signal for 5 seconds.

Run the Clean Washer cycle monthly. See "Cleaning Your

Washer" in "Washer Maintenance."

Unload washer as soon as cycle is complete.

Use only HE detergent. Be sure to measure correctly.

Always follow the manufacturer's directions.

See "Cleaning your Washer" section.

If excess suds are detected, the washer will add extra rinsing

and pauses to break down suds. This will lengthen the cycle

time. Use only HE detergent. Be sure to measure correctly.

Load dry items in loose heaps evenly around basket wall.

Adding wet items to washer or adding more water to basket

could unbalance washer. Redistribute the load more evenly

without covering the washplate, then select Rinse & Spin cycle

and restart the washer.

Solution