Whirlpool 7MWTW1950EW Kurulum Talimatları Kılavuzu - Sayfa 7

Yıkayıcı Whirlpool 7MWTW1950EW için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Whirlpool 7MWTW1950EW 16 sayfaları. Top-loading washer
Ayrıca Whirlpool 7MWTW1950EW için: Kullanım ve Bakım Kılavuzu (33 sayfalar)

Sayfayı Yazdır
12.
Secure drain hose
Laundry Tub
Standpipe
4.5"
4.5"
4.5"
(114 mm)
(114 mm)
(114 mm)
Secure drain hose to laundry tub leg, drain standpipe, or inlet
hoses for wall standpipe with cable tie.
It is the responsibility of the installer to install and secure the
drain hose into the provided plumbing/drain in a manner that
will avoid the drain hose coming out of or leaking from the
plumbing/drain.

LEVEL WASHER

IMPORTANT: Level washer properly to reduce excess noise
and vibration.
13.
Check levelness of washer
Place level here
Move the washer to its final location. Place a level on top
edges of washer. Use side seam as a guide to check
levelness of sides. Check levelness of front using lid as
shown. Rock washer back and forth to make sure all four
feet make solid contact with floor. If washer is level, skip to
step 15, (on models with metal feet) or step 16 (on models
with plastic feet).
Not Level
Wall
(114 mm)
(113 mm)
Place level here
LEVEL
Not Level
14.
Adjust leveling feet
4.5"
4.5"
Jam nut
If washer is not level:
On models with metal feet, use a
adjustable wrench to turn jam nuts clockwise on feet until they
are about ½" (13 mm) from the washer cabinet. Then turn the
leveling foot clockwise to lower the washer or counterclockwise
to raise the washer.
On models with plastic feet, use adjustable pliers to turn the
plastic leveling foot counterclockwise to lower the washer or
clockwise to raise the washer. On all models, recheck levelness
of washer and repeat as needed.
HELPFUL TIP: You may want to prop up front of washer
about 4" (102 mm) with a wood block or similar object that
will support weight of washer.
15.
Tighten leveling feet
Jam nut
On models with metal feet, when washer is level, use a
⁄
9
" or 14 mm open-end or adjustable wrench to turn jam
16
nuts counterclockwise on leveling feet tightly against
washer cabinet.
HELPFUL TIP: You may want to prop washer with
wooden block.
Models with
metal feet
or
Models with
plastic feet
⁄
9
" or 14 mm open-end or
16
7