Whirlpool 8182042 Kullanım ve Bakım Kılavuzu - Sayfa 11

Yıkayıcı Whirlpool 8182042 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. Whirlpool 8182042 44 sayfaları. Front-loading automatic washer

Sayfayı Yazdır

4. Turn on the washer by selecting CONTROL ON. Select one of

the cycles by turning the cycle selector. The indicator light for

the selected cycle will glow. When selecting a wash cycle, the

preset Options, Water Temp, Spin Speed, and Soil Level for

the selected cycle will glow. The display shows the estimated

time remaining. The preset settings provide the

recommended fabric care for the selected cycle. See

"Cycles."

5. Select the desired OPTIONS. Not all options are available

with all cycles. See "Options."

6. Select the desired MODIFIERS. Not all modifiers are available

with all cycles and options. See "Modifiers."

7. If desired, select the END OF CYCLE SIGNAL. The signal is

helpful when you are washing items that should be removed

from the washer as soon as it stops. Select LOUDER or

SOFTER.

8. To begin the wash cycle immediately

Select HOLD TO START.

If you do not select HOLD TO START within 5 minutes of

choosing a cycle, the washer automatically shuts off.

When the wash cycle is complete, the CYCLE

COMPLETE status light glows, the door unlocks, and the

wash load can be removed from the washer. The washer

powers down automatically 5 minutes after the cycle is

complete and the CYCLE COMPLETE light goes off. To

power down the washer manually after the wash cycle is

complete, select PAUSE/CANCEL once.

9. To begin the wash cycle later

Select DELAY WASH until the desired delay time (in hours)

shows in the Estimated Time Remaining display. Select

START. The countdown to the wash cycle will show in the

display window.

Using the Dispenser

Your new washer has a dispenser drawer with four separate

compartments for your laundry products—two are for detergent,

one is for liquid chlorine bleach, and one is for liquid fabric

softener. Laundry products are diluted and dispensed

automatically at the proper time during the wash cycle, making it

unnecessary for you to return to the washer during the cycle to

add them.

It is normal for small amounts of water to remain in the

dispensers when the wash cycle is complete.

Do not put laundry additives directly into the wash tub. Always

use the proper dispensers when adding laundry products.

Choosing the Right Detergent

For best washing performance, use a High Efficiency (HE), or

low-sudsing, detergent. Regular detergents may cause

oversudsing in the washer. If a High Efficiency detergent is

unavailable, use

the recommended amount of regular

detergent. Use of Regular detergent will lead to unsatisfactory

performance over time.

Most detergents formulated for hand-washing are not meant for

front-loading washers and may cause oversudsing. Start with ¼

the recommended amount. If oversudsing occurs, try a detergent

formulated for high efficiency washers.

To fill dispenser compartments

1. Pull out the dispenser drawer.

2. Add the desired laundry product to the proper compartment.

3. Push in the dispenser drawer carefully and completely (to

avoid spillage).

1. Prewash detergent compartment

2. Separator

3. Main Wash detergent compartment

4. Dispenser release lever

5. Bleach compartment

6. Fabric softener compartment

Prewash detergent compartment

(Number 1 in Dispenser Illustration)

Add detergent to this compartment when using the Prewash

option or Auto Soak. Liquid or powdered detergent may be used

in this compartment. The detergent will automatically be

dispensed during Prewash if the Prewash option is selected or

during the soak time if Auto Soak is selected.

If you use High Efficiency (HE) detergent, add

recommended amount to the Prewash compartment and

the recommended amount to the Main Wash compartment.

If you use regular detergent, add

amount to the prewash compartment and

recommended amount to the Main Wash compartment.

Dispenser

the

of the recommended

of the