Whirlpool 8559 Kullanım Kılavuzu - Sayfa 7

Yıkayıcı Whirlpool 8559 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Whirlpool 8559 13 sayfaları. 8kg, 1200rpm, washing machine with microban anti-bacterial protection 8003437443664 awoe 8559

Sayfayı Yazdır

30106320GB.fm Page 7 Tuesday, December 1, 2009 10:47 AM

DRAINING RESIDUAL WATER/

CLEANING THE FILTER

We recommend that you check and clean the filter

regularly, at least two or three times a year, especially:

• If the "Clean pump" indication

• If the appliance is not draining properly or if it fails to

perform spin cycles.

If the washing machine stands in a room prone to frost, you

have to drain residual water after each wash to avoid damages.

IMPORTANT: make sure the water has cooled

before draining the appliance.

If your washing machine has no emergency hose, proceed

as described at the end of this page.

1. Stop the appliance and unplug it.

2. Push down the tabs right and left to release the plinth

and remove it (picture "A").

3. Place a container near the washing machine.

4. Press slightly together the tabs of the hose stopper to

release the emergency hose and pull it out of the

washing machine's base (picture "B").

5. Hold the emergency hose's end into the container and

remove the stopper (picture "C").

6. Wait until all the water has drained, then refix the stopper

at the hose's end (picture "D").

7. Push the hose back into the washing machine's base.

8. Lay an absorbable cotton cloth (e.g. a towel) on the

floor in front of the filter.

9. Slowly open the filter by turning it counter-clockwise

(picture "E"); wait until all the water has drained, then

unscrew the filter completely and remove it.

10. Tilt the appliance forwards carefully (a second person

must help you) to allow the water to flow out completely.

11. Clean the filter and the filter chamber; check that the

pump rotor in the filter chamber moves freely.

12. Reinsert the filter and screw it in clockwise as far as it

will go.

13. Pour about 1 litre of water into the detergent

dispenser to reactivate the "Eco system". Check that

the filter is inserted properly and securely and no

water comes out.

14. Reinstall the plinth (picture "F"); if necessary, tilt the

washing machine slightly backwards for doing that (a

second person must help you).

15. Plug in the washing machine.

The washing machine is now ready for operation again.

If your washing machine has no emergency hose:

Follow the steps above but neglect steps 4 to 7.

Step 8: do not lay an absorbable cotton cloth in front

of the filter but place a broad and flat container

beneath the filter to collect the outcoming water.

Black process 45.0° 130.0 LPI

lights up.

GB 7