Whirlpool AWM 4066 Manuel - Sayfa 2

Yıkayıcı Whirlpool AWM 4066 için çevrimiçi göz atın veya pdf Manuel indirin. Whirlpool AWM 4066 18 sayfaları.

Sayfayı Yazdır
CONSUMPTION DATA
Temperature
Selector
Programme
(°C)
Cotton with prewash
95
Cotton
95
Cotton
60
Synthetics
60
Cotton short
40
Synthetics short
40
Delicate
40
Wool
40
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized
conditions in compliance with Standard IEC 60 456. Consumption data in the home may vary with respect to the values in
the table in relation to the water supply pressure and temperature, the load and the type of wash. The data on the energy
label refer to the programme Cotton 60°C.
ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE
PROGRAMME
Add the detergents as described in the programme
table or in the chapter "Detergents and Additives" in
the booklet.
1. Open the tap.
2. Set the programme selector to the desired
programme.
3. Set the temperature selector to the desired
temperature.
4. Special options can be selected.
5. Check that the door is well closed and turn on the
washing machine by pressing the "ON/OFF"
button. The indicator lights up, indicating that
the washing machine is on.
Load
Water
Energy
Estimated Programme
(kg)
(l)
(kWh)
5.0
80
2.00
5.0
70
1.80
5.0
70
1.20
2.0
60
0.90
2.5
65
0.70
2.5
60
0.60
1.5
80
0.60
1.0
80
0.60
SELECT ANY DESIDERED OPTION
"Half Load" button
• Reduces water consumption, above all during rinsing.
Suitable for lightly-soiled laundry and small loads
(max 3 kg).
"No Spin" button
• Excludes spinning from programme, press button.
Suitable for delicate laundry.
Note: with the "Cotton" and "Synthetic" programmes
a short spin cycle is provided in any case, even if the
exclusion has been selected, in order to optimize
rinsing results.
"Rinse Hold" button
• The laundry remains in the last rinse water
without progressing to the final spin cycle to
avoid creasing and prevent colours from
changing.
• This option is particularly recommended for the
programme "Synthetic" or "Delicate".
• This function is particularly useful if you want to
postpone spinning to a later time, or if you want
to drain only.
Terminate the "Rinse Hold" option:
• Press the "Rinse Hold" button again; the
programme will terminate automatically with
Duration
the final spin cycle for the present wash
Min.
programme.
120
If you do not wish to spin the laundry, turn the
programme selector knob to the "Drain"
110
programme.
110
"Gentle Wash" button
85
• Reduces the mechanical wash strenght from
75
strong to delicate.
75
PROGRAMME CHANGE
70
65
To reselect a programme when a cycle has already
started:
1. Switch off the appliance by pressing the "ON/
OFF" button.
2. Select the new programme, temperature and
options.
3. Start the programme by pressing the "ON/OFF"
button again.
PROGRAMME END
1. At the end of the programme the programme
selector moves to the stop position.
2. To unload the washing machine wait for the
door to unlock (about 2 minutes).
3. Switch off the washing machine, open the door
and take out the laundry.
4. Close the tap and leave the door ajar to allow
the drum to dry out.
NOTES AND INDICATIONS FOR USE
Water level
To obtain low water consumption without
compromising washing results the water level
within the drum may not be visible.
Cleaning the pump filter
A regular filter check and eventual cleaning is
advisable.
Motor smell
Washing machine motor creates a typical electrical
smell during first cycles, this is normal and
disappears after a few cycles.
Whirlpool is a registered trademark of Whirlpool USA.
5019 301 10039