Whirlpool AWM 6120 Kullanım Kılavuzu - Sayfa 20

Yıkayıcı Whirlpool AWM 6120 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Whirlpool AWM 6120 22 sayfaları. Front-loading washer
Ayrıca Whirlpool AWM 6120 için: Servis Kılavuzu (19 sayfalar)

Sayfayı Yazdır

Worktop for built-under models

The appliance must only be installed beneath a continuous fitted kitchen worktop.

If the appliance will be built under it is mandatory to use the cover panel UBS. This can be obtained

from specialist shops or from After-Sales Service.

1.Unplug the appliance.

2.Unscrew the worktop fixing screws from the rear of the appliance.

3.Slide the worktop fully backward and lift it upwards to remove. Install the cover panel following the

relative instructions.

4.Refit the fixing screws and tighten them.

5.Plug the appliance only into the mains power socket.

Connect the water inlet hose

For models with straight hose "A"

1.Insert the dirt strainer (already premounted on the hose end or

included in the accessories) into the threaded tap coupling.

2.Carefully screw the hose connection onto the tap preferably by hand.

3.Make sure there are no kinks in the hose.

4.Check water-tightness of tap and appliance connections by turning the

tap completely on.

If the hose is too short, replace it with a suitable length of pressure

resistant hose (1000 kPa min, EN 50084 approved type).

Periodically check the hose for brittleness and cracks and replace if

necessary.

The appliance can be connected without an anti-backpressure valve.

For models with Water Stop hose "B"

If the flexible hose is damaged, unplug the appliance from the mains

immediately.

1.Screw the threaded connector with the filter inserted onto the tap.

2.Check water-tightness of tap and appliance connections by turning

the tap completely on.

If the hose is too short, replace it with a 3 m Water Stop hose (available

from After-Sales Service or from your dealer). This operation must be

carried out exclusively by a licensed electrician.

The appliance must not be connected to the mixing tap of a non-

pressurized water heater.

The inlet hose and the plastic enclosure at the tap connection contain

electrical components. Do not cut the hose and do not immerse the

plastic enclosure in water.