Whirlpool AWM 8712 Kullanım Kılavuzu - Sayfa 12
Yıkayıcı Whirlpool AWM 8712 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Whirlpool AWM 8712 15 sayfaları.
Sayfayı YazdırDescription of red indications
Red indication
lights up
"Water tap closed"
"Clean pump"
Indication on big
display
(if available on your
model)
Appliance has no or insufficient water supply. The
"Start/Pause" light blinks.
Check whether:
• Water tap is fully open and water supply pressure
• Kinks are present in the water inlet hose.
• Mesh filter of water supply hose is blocked (see
• The water hose is frozen up.
• The safety valve inspection window of your water
---
After problem has been removed, restart
programme by pressing "Start/Pause". If the fault
occurs again, contact our After-Sales Service (see
next chapter).
Waste water is not pumped out. The appliance
stops in the corresponding programme step; unplug
it and check whether:
• Kinks are present in the drain hose, or the hose is
• Filter or pump is blocked (see chapter "Draining
---
• The drain hose is frozen up.
After problem has been removed, push the "Reset"
button for at least 3 seconds; afterwards restart the
desired programme. If the fault occurs again,
contact our After-Sales-Service (see next chapter).
GB 11
Description
Causes
Solutions
is sufficient.
"Care And Maintenance".
supply hose is red (provided your appliance has a
water supply hose as shown on picture "B" - see
previous chapter "Care And Maintenance");
replace the hose by a new one available through
our After-Sales Service or your specialist dealer.
blocked for another reason.
Residual Water/ Removing The Filter"; make sure
the water has cooled before draining the
appliance).