Whirlpool AWO/D 42420 Kullanıcı Kılavuzu - Sayfa 24

Yıkayıcı Whirlpool AWO/D 42420 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Whirlpool AWO/D 42420 32 sayfaları.

IFU Delta-Domino_LR+HR-GB.fm Page 7 Wednesday, December 13, 2006 6:04 PM

REMOVING THE FILTER/DRAINING

RESIDUAL WATER

We recommend that you check and clean the filter

regularly, at least two or three times a year.

Especially:

• If the appliance is not draining properly or if it fails to

perform spin cycles.

• If the "Clean filter" indication lights up:

IMPORTANT: make sure the water has cooled

before draining the appliance.

1. Stop the appliance and unplug it.

2. Remove the plinth or open the cover (depending on

the model) by using the separator of the detergent

dispenser (fig. A / B).

3. Place a container beneath it. If your washing machine

has the filter situated behind the plinth (see pictures

"A" and "C"), use a broad and very flat container with

a maximum height of 2 cm.

4. Open the filter but do not remove it completely.

Slowly turn the filter counterclockwise (fig. C) until the

water begins to drain out.

5. Wait until all the water has drained.

6. Now unscrew the filter completely and remove it.

7. Tilt the appliance forwards carefully to allow the water

to flow out.

8. Clean the filter and the filter chamber.

9. Check that the pump rotor moves freely.

10. Re-insert the filter and screw it in clockwise as far as it

will go.

11. Pour about 1 litre of water into the detergent drawer

to reactivate the "Eco system". Check that the filter is

inserted properly and securely.

12. Reinstall the plinth or the cover, depending on the

model.

13. Plug in the appliance again.

14. Select a programme and start it.

GB 7