3Com 3C433279A Yayın Notu - Sayfa 5
Ağ Donanımı 3Com 3C433279A için çevrimiçi göz atın veya pdf Yayın Notu indirin. 3Com 3C433279A 12 sayfaları. Superstack ii remote access system 1500
Parameter
PUBLIC_PORT
PUBLIC_PORT
Note: PAT can only be used when the ISP has provided only one IP
address. This one IP address will dynamically change with each new
connection.
Dynamic NAT
Release 2.5 includes support for Dynamic Network Address Translation
(NAT) over the WAN interface. Dynamic NAT configures and associates a
name with a specific number of ISP-assigned addresses.
You can set Dynamic NAT through the Web Configuration Interface. From
the main, browser-based Web Configuration Interface page, click Select
NAT/PAT Configuration under the Network menu, choose NAT and
supply the following parameters:
You can also set Dynamic NAT using CLI. The CLI command for adding
Dynamic NAT over the WAN interface is as follows:
ADD NAT DYNAMIC USER <USER_NAME>
This command should be followed sequentially by the following sub
commands. See the table below for definitions of the parameters.
COUNT <NUMBER OF ADDRESSES>
PUBLIC_POOL_START<IP_ADDRESS>
Parameter
<USER_ NAME>
COUNT
Description
The destination port number of the ISP-assigned IP
address on the public network.
The port number of the single ISP-assigned IP address
on the public network.
User name
Starting IP Address
Number of Addresses
Subnet Mask
Description
Unique name that you want to assign the connection
that uses Dynamic NAT to map ISP-assigned addresses
to connections on the private network. Limit: 32 ASCII
characters.
Total number of ISP-assigned addresses starting with
the public_pool_start address that is used by the RAS
1500 for Dynamic NAT mapping.
New Features
5